Eureka Easyclean 71C Power Cord Replacement Repair Guide

Difficulty

Difficult

Steps

9

Time Required

                          15 minutes            

Sections

3

• Bottom Cover
• 4 steps
• Casing
• 2 steps
• Power Cord
• 3 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

• BackEureka EasyClean 71C

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover               

• Unscrew the two 18.1 mm PH2 Phillips head screws on the bottom of the vacuum.

Unscrew the two 18.1 mm PH2 Phillips head screws on the bottom of the vacuum.

1024

Step 2

• Pry off the Riser Visor using the plastic opening tool.

Pry off the Riser Visor using the plastic opening tool.

Step 3

• Remove the screw cap using the metal spudger.
• First-time removal of the screw cap can be difficult. The screw cap isn’t vital, so don’t worry about damaging the screw cap and just keep trying until it comes out.

Remove the screw cap using the metal spudger.

First-time removal of the screw cap can be difficult. The screw cap isn’t vital, so don’t worry about damaging the screw cap and just keep trying until it comes out.

Step 4

• Unscrew the 14mm PH2 Phillips head screw.
• Pull the bottom cover off of the rest of the casing.

Unscrew the 14mm PH2 Phillips head screw.

Pull the bottom cover off of the rest of the casing.

Step 5

              Casing               

• Pull the power switch all the way up and remove the dust cup.

Pull the power switch all the way up and remove the dust cup.

Step 6

• Unscrew the six 18.1mm PH2 Phillips head screws on the side of the vacuum.
• Pull the casing apart.

Unscrew the six 18.1mm PH2 Phillips head screws on the side of the vacuum.

Pull the casing apart.

Step 7

              Power Cord               

• Pull out the switch board.
• Ensure the vacuum is powered off and unplugged before handling any electronics.

Pull out the switch board.

Ensure the vacuum is powered off and unplugged before handling any electronics.

Step 8

• Desolder the highlighted black and white wires.
• For instructions on how to solder and desolder wires, visit this guide.

Desolder the highlighted black and white wires.

For instructions on how to solder and desolder wires, visit this guide.

Step 9

• Unscrew the 22.3mm PH2 Phillips head screw.
• Remove the power cord.

Unscrew the 22.3mm PH2 Phillips head screw.

Remove the power cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Tanner Durnil                     

Member since: 11/06/2017

631 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       IUPUI, Team S6-G4, Baechle Fall 2017                        

                                                  Member of IUPUI, Team S6-G4, Baechle Fall 2017 



                    IUPUI-BAECHLE-F17S6G4                     


                                            3 Members                     


                                            12 Guides authored