Eureka 1660Sp Pole Extender Button Spring Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          10 minutes            

Sections

2

• Motor Housing
• 3 steps
• Pole Extender Button Spring
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackEureka The Boss 3-in-1 166OSP

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Motor Housing               

• Before you start, make sure your vacuum is unplugged the power outlet.
• Press and hold down the black button below the handle while pulling the pole out.

Before you start, make sure your vacuum is unplugged the power outlet.

Press and hold down the black button below the handle while pulling the pole out.

1024

Step 2

• Press the black separator switch to separate the top and bottom halves of the vacuum.

Press the black separator switch to separate the top and bottom halves of the vacuum.

Step 3

• Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.
• Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.
• Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

Step 4

              Pole Extender Button Spring               

• Pull out the button and the spring attached to it.
• Swap the old spring with a new one.

Pull out the button and the spring attached to it.

Swap the old spring with a new one.

Step 5

• Insert the new spring and button back into the right slot as shown in the picture.

Insert the new spring and button back into the right slot as shown in the picture.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Nikhila Vijaybhaskar                     

Member since: 09/24/2013

233 Reputation

                                      2 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013                        

                                                  Member of UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 



                    UMASSD-GULBRANDSEN-F13S1G1                     


                                            3 Members                     


                                            12 Guides authored