Difficulty

Moderate

Steps

5

Time Required

                          15 minutes

Sections

2

  • Motor Housing
  • 3 steps
  • Realignment of the extendable pole
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackEureka The Boss 3-in-1 166OSP

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Motor Housing
  • Before you start, make sure your vacuum is unplugged the power outlet.
  • Press and hold down the black button below the handle while pulling the pole out.

Before you start, make sure your vacuum is unplugged the power outlet.

Press and hold down the black button below the handle while pulling the pole out.

1024

Step 2

  • Press the black separator switch to separate the top and bottom halves of the vacuum.

Press the black separator switch to separate the top and bottom halves of the vacuum.

Step 3

  • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.
  • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.
  • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

Step 4

              Realignment of the extendable pole
  • Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

Once the housing is open, locate the solid chrome plated piece at the front end of the extendable pole.

Step 5

  • On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing.
  • Re-insert the chrome plated piece into the center track.

On the side of the motor housing which does not hold the engine, find the center track which runs along the inside of the housing.

Re-insert the chrome plated piece into the center track.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors 


                    Evan Fodi

Member since: 09/24/2013

122 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013                        

                                                  Member of UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 



                    UMASSD-GULBRANDSEN-F13S1G1                     


                                            3 Members                     


                                            12 Guides authored