Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

2

  • Front Cover and Motherboard
  • 5 steps
  • Rolling Brush
  • 1 step

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • Backeufy RoboVac 11

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Cover and Motherboard
  • Remove the nine 10 mm screws with the Phillips #1 precision screwdriver.
  • Keep track of these screws. They are the same length as the interior screws but wider in diameter.

Remove the nine 10 mm screws with the Phillips #1 precision screwdriver.

Keep track of these screws. They are the same length as the interior screws but wider in diameter.

1024

Step 2

  • Remove the six 7 mm screws on the bumper with the Phillips #1 screwdriver.

Remove the six 7 mm screws on the bumper with the Phillips #1 screwdriver.

Step 3

  • Remove the top plate from the body of the device.
  • Unplug the bumper from the motherboard.

Remove the top plate from the body of the device.

Unplug the bumper from the motherboard.

Step 4

  • Remove the three 10 mm motherboard screws with a Phillips #1 screwdriver.
  • Cleaning the motherboard and inside of the device outdoors with a compressed air cleaner will help the robot last longer.

Remove the three 10 mm motherboard screws with a Phillips #1 screwdriver.

Cleaning the motherboard and inside of the device outdoors with a compressed air cleaner will help the robot last longer.

Step 5

  • Unplug the cables from the motherboard.

Unplug the cables from the motherboard.

Step 6

              Rolling Brush
  • Remove the single 10 mm screw with the Phillips #1 screwdriver.
  • Remove the rolling brush.

Remove the single 10 mm screw with the Phillips #1 screwdriver.

Remove the rolling brush.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Myles Mattinson

Member since: 09/28/2022

301 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Utah Tech University, Team 1-3, McMurrin Fall 2022                        

                                                  Member of Utah Tech University, Team 1-3, McMurrin Fall 2022 



                    UTAHTECH-MCMURRIN-F22S1G3                     


                                            3 Members                     


                                            6 Guides authored