Difficulty

Moderate

Steps

8

Time Required

                          20 minutes

Sections

3

  • Exterior Case
  • 3 steps
  • Lens
  • 2 steps
  • Speaker
  • 3 steps

Flags

0

  • BackEscort Passport Max2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Exterior Case
  • Inser the flat end of a spudger into one of the two notches and pry off the case.

Inser the flat end of a spudger into one of the two notches and pry off the case.

1024

Step 2

  • Slide the spudger around the perimeter of the radar housing until the case separates.

Slide the spudger around the perimeter of the radar housing until the case separates.

Step 3

  • Repeat these steps to remove the other side.

Repeat these steps to remove the other side.

Step 4

              Lens
  • Remove the four 9mm Phillips #1 screws from the bottom of the radar.
  • Remove the bottom case.

Remove the four 9mm Phillips #1 screws from the bottom of the radar.

Remove the bottom case.

Step 5

  • Gently spread apart the thin silver frame that wraps around the device and remove the dark purple lens.
  • The silver frame can easily pop off of the device now that the bottom metal case has been removed. Don’t worry if it comes off all the way. It can easily be put back in it’s place.

Gently spread apart the thin silver frame that wraps around the device and remove the dark purple lens.

The silver frame can easily pop off of the device now that the bottom metal case has been removed. Don’t worry if it comes off all the way. It can easily be put back in it’s place.

Step 6

              Speaker
  • Use the plastic opening tool to unplug the white connector from the motherboard.
  • Remove the motherboard.

Use the plastic opening tool to unplug the white connector from the motherboard.

Remove the motherboard.

Step 7

  • Simultaneously, press on the small tab with the flat end of the metal spudger and lift the lid of the box.
  • The speaker part should come up as well when you lift the lid of the box.

Simultaneously, press on the small tab with the flat end of the metal spudger and lift the lid of the box.

The speaker part should come up as well when you lift the lid of the box.

Step 8

  • The speaker will easily separate from the lid.
  • Be careful of the red and black cord, which is threaded through one part of the lid. When replacing the speakers be sure to gently pull the cord through this hole to fully release the speaker part.

The speaker will easily separate from the lid.

Be careful of the red and black cord, which is threaded through one part of the lid. When replacing the speakers be sure to gently pull the cord through this hole to fully release the speaker part.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Kelsey Ferrenberg

Member since: 04/12/2018

710 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Tacoma, Team S1-G1, Liner Spring 2018                        

                                                  Member of UW Tacoma, Team S1-G1, Liner Spring 2018 



                    UWT-LINER-S18S1G1                     


                                            5 Members                     


                                            4 Guides authored

Chris Taylor - Apr 24, 2021

Reply

Do you have a link to the replacement speaker part

Sar - Aug 19, 2021

Reply