Epson Stylus Nx305 Scanner Motor Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Scanner Motor
9 steps

Flags

BackEpson Stylus NX305
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Scanner Motor

Make sure that the printer is not plugged in before working on it.
Orient the printer so that the back of it is facing you.

Make sure that the printer is not plugged in before working on it.

Orient the printer so that the back of it is facing you.

1024

Step 2

Locate the 3mm Phillips #0 screw that is on the right-hand side of the printer.
Using a Phillips head screwdriver, remove the screw.

Locate the 3mm Phillips #0 screw that is on the right-hand side of the printer.

Using a Phillips head screwdriver, remove the screw.

Step 3

Open up the lid of the printer.
With the printer facing away from you, lift up on the right hand side of the lid of the printer and slide it to the left to remove it.
Be careful not to remove the white ribbon and wires that are connected.

Open up the lid of the printer.

With the printer facing away from you, lift up on the right hand side of the lid of the printer and slide it to the left to remove it.

Be careful not to remove the white ribbon and wires that are connected.

Step 4

With the printer facing you, open the lid of the scanner to expose the 3mm Phillips #0 screw at the top left of the scanner.
Using a Phillips head screwdriver, remove the screw.

With the printer facing you, open the lid of the scanner to expose the 3mm Phillips #0 screw at the top left of the scanner.

Step 5

Locate the six 3mm Phillips #2 screws under the lid of the printer and remove them.

Locate the six 3mm Phillips #2 screws under the lid of the printer and remove them.

Step 6

Locate the three clips on the front side of the printer lid.
Use the plastic opening tool to release the clips and carefully pry open the lid.

Locate the three clips on the front side of the printer lid.

Use the plastic opening tool to release the clips and carefully pry open the lid.

Step 7

Locate the belt that is attached to the scanner motor and remove it by carefully stretching off of the gear.

Locate the belt that is attached to the scanner motor and remove it by carefully stretching off of the gear.

Step 8

Remove the two 3mm Phillips #2 screws from the scanner motor assembly.
Carefully lift the scanner motor assembly out of the housing making sure not to damage the wiring.

Remove the two 3mm Phillips #2 screws from the scanner motor assembly.

Carefully lift the scanner motor assembly out of the housing making sure not to damage the wiring.

Step 9

Flip over the scanner motor assembly to expose the scanner motor.
Remove the two 3mm Phillips #2 screws from the assembly and remove the motor.

Flip over the scanner motor assembly to expose the scanner motor.

Remove the two 3mm Phillips #2 screws from the assembly and remove the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Jeffrey Barnett

Member since: 09/21/2014

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       USF Tampa, Team 1-2, Donnelly Fall 2014                        

                                                  Member of USF Tampa, Team 1-2, Donnelly Fall 2014 



                    USFT-DONNELLY-F14S1G2                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team