Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
1
- Motherboard
- 7 steps
Flags
0
BackEpson Stylus NX230
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Check to make sure the printer is unplugged to prevent electric shock.
Check to make sure the printer is unplugged to prevent electric shock.
1024
Step 2
- Align your printer so that the front buttons face to the right.
- Remove the 3mm Phillips #2 screw in the hole in the top left corner. This screw attaches the side panel to the printer.
- Store the screws in a safe place so you can access them later.
Align your printer so that the front buttons face to the right.
Remove the 3mm Phillips #2 screw in the hole in the top left corner. This screw attaches the side panel to the printer.
Store the screws in a safe place so you can access them later.
Step 3
- Flip and remove the top of the printer up so that you can see the inside.
- There is a white strip in the top right corner of the printer called the ribbon cable.
- Make sure that the ribbon cable does not detach from the printer to prevent damaging the connection.
Flip and remove the top of the printer up so that you can see the inside.
There is a white strip in the top right corner of the printer called the ribbon cable.
Make sure that the ribbon cable does not detach from the printer to prevent damaging the connection.
Step 4
- Align the printer so the front button panel faces to the right.
- Remove the 3mm Phillips #2 screw on the side of the printer in the top left corner.
- Store the screw in a safe place so you can access it later.
Align the printer so the front button panel faces to the right.
Remove the 3mm Phillips #2 screw on the side of the printer in the top left corner.
Store the screw in a safe place so you can access it later.
Step 5
- Take the right side of the bar of plastic that runs across the top of the inside of the printer and push it towards the left side of the printer.
- Take the left side of the bar and push it to the left and then to the right.
Take the right side of the bar of plastic that runs across the top of the inside of the printer and push it towards the left side of the printer.
Take the left side of the bar and push it to the left and then to the right.
Step 6
- Using your hands, detach the side panel from the printer.
- Take extra care with the locking mechanisms, which help keep the side panel on the printer.
- You may need to use the plastic opening tools to pry apart the locking mechanisms.
Using your hands, detach the side panel from the printer.
Take extra care with the locking mechanisms, which help keep the side panel on the printer.
You may need to use the plastic opening tools to pry apart the locking mechanisms.
Step 7
- Remove the two 3mm Phillips #2 screws attaching motherboard to the printer.
- Store the screws in a safe place so you can access them later.
- The motherboard can now be removed from the printer.
Remove the two 3mm Phillips #2 screws attaching motherboard to the printer.
The motherboard can now be removed from the printer.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Kimberly Pugel
Member since: 04/07/2014
389 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 6-1, Forte Spring 2014
Member of Cal Poly, Team 6-1, Forte Spring 2014
CPSU-FORTE-S14S6G1
4 Members
5 Guides authored
