Epson Powerlite 410W Lamp Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Lamp
4 steps

Flags

BackEpson Powerlite 410W
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

The lamp is a piece of equipment that comes with the projector, and it helps to project an image onto the corresponding screen. A faulty lamp is one that may be producing a distorted image onto the screen you are projecting to. In some cases, your projector may not produce an image at all if the lamp starts to produce a distorted image.

Before using this replacement guide, make sure to review the troubleshooting page - oftentimes, a distorted image can be fixed without replacing the lamp.

When you are disposing of your old lamp, make sure to check out your state’s requirements for disposal of the lamp, since it does contain mercury.

Once you have installed the new lamp, remember to reset the lamp timer in the menu.

What you need

Step 1

              Lamp

Press the power button located on top of the projector.
Remember to let the projector cool off completely after turning off the power before beginning the repair.

Press the power button located on top of the projector.

Remember to let the projector cool off completely after turning off the power before beginning the repair.

1024

Step 2

Loosen the single captive screw holding the lamp cover in place using a Phillips #2 screwdriver.
Slide the cover out, then lift it off and place to the side.

Loosen the single captive screw holding the lamp cover in place using a Phillips #2 screwdriver.

Slide the cover out, then lift it off and place to the side.

Step 3

Loosen the two captive screws that hold the lamp in place using a Phillips #2 screwdriver.

Loosen the two captive screws that hold the lamp in place using a Phillips #2 screwdriver.

Step 4

Use your hands to pull the lamp straight out of the projector.
When inserting the new lamp, push the lamp down firmly, where the label “PUSH” appears.

Use your hands to pull the lamp straight out of the projector.

When inserting the new lamp, push the lamp down firmly, where the label “PUSH” appears.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Sophia Sanders

Member since: 01/08/2022

229 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Illinois Wesleyan University, Team 1-4, Bullock Spring 2022                        

                                                  Member of Illinois Wesleyan University, Team 1-4, Bullock Spring 2022 



                    IWU-BULLOCK-S22S1G4                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team