Difficulty
Easy
Steps
3
Time Required
2 - 8 minutes
Sections
1
- Projector Lamp
- 3 steps
Flags
0
BackEpson Home Cinema 2150
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The Epson Home Cinema 2150 Lamp is located under an accessible panel for quick replacement. For this guide, only a Phillips #2 screwdriver is needed.
What you need
Step 1
Projector Lamp
- Disconnect and cool the device to room temperature. Failure to do so may result in electric shock or minor burns.
- Orient the Epson Home Cinema 2150 so that the large indented panel faces your direction.
- Unscrew the single 6mm Phillips#2 holding screw from the access panel.
- Slide the panel horizontally, then lift up to remove the access panel.
Disconnect and cool the device to room temperature. Failure to do so may result in electric shock or minor burns.
Orient the Epson Home Cinema 2150 so that the large indented panel faces your direction.
Unscrew the single 6mm Phillips#2 holding screw from the access panel.
Slide the panel horizontally, then lift up to remove the access panel.
1024
Step 2
- Loosen and remove the two screws holding the lamp.
- Remove two 9 mm Phillips #2 screws.
Loosen and remove the two screws holding the lamp.
Remove two 9 mm Phillips #2 screws.
Step 3
- Using four fingers, pull upwards on the lamp’s plastic casing.
- You may feel some resistance when pulling the lamp.
Using four fingers, pull upwards on the lamp’s plastic casing.
You may feel some resistance when pulling the lamp.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Luis Garcia
Member since: 09/26/2022
577 Reputation
4 Guides authored
Badges:
5
+2 more badges
Team
CSU Los Angeles, Team 6-2, Adachi Fall 2022
Member of CSU Los Angeles, Team 6-2, Adachi Fall 2022
CSULA-ADACHI-F22S6G2
4 Members
5 Guides authored