Envizen V100M Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          10 - 20 minutes            

Sections

2

• Back Cover
• 2 steps
• Speakers
• 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackEnvizen V100M

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Back Cover               

• Remove the two screws on the side of the tablet that hold the back cover in place using the ifixit PH00 screwdriver.
• The two screws for the back cover are: 1.5mm diameter x 3.5mm long

Remove the two screws on the side of the tablet that hold the back cover in place using the ifixit PH00 screwdriver.

The two screws for the back cover are: 1.5mm diameter x 3.5mm long

1024

Step 2

• Pry along the edge of the device to separate the back cover from the device.
• The speakers are attached to the back cover and motherboard assembly so remove carefully.

Pry along the edge of the device to separate the back cover from the device.

The speakers are attached to the back cover and motherboard assembly so remove carefully.

Step 3

              Speakers               

• Check to see if the wires of the speakers are connected to the motherboard assembly here.

Check to see if the wires of the speakers are connected to the motherboard assembly here.

Step 4

• take the wires of one of the speakers and solder them back on the mother board, as shown. Remember, Red is always positive (+) and Black is always negative (-). here is a guide on how to solder.

take the wires of one of the speakers and solder them back on the mother board, as shown. Remember, Red is always positive (+) and Black is always negative (-). here is a guide on how to solder.

Step 5

• Repeat the same process for the second speaker. The other set of terminals for the second speaker is directly next to the first set.

Repeat the same process for the second speaker. The other set of terminals for the second speaker is directly next to the first set.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    nbach                     

Member since: 03/23/2015

663 Reputation

                                      6 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       UMass Dartmouth, Team 3-2, Duarte Spring 2015                        

                                                  Member of UMass Dartmouth, Team 3-2, Duarte Spring 2015 



                    UMASSD-DUARTE-S15S3G2                     


                                            4 Members                     


                                            12 Guides authored