Emson Star Wars R2 D2 Humidifier Led Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Blue LED
7 steps

Flags

BackEmson Star Wars R2-D2 Humidifier
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Blue LED

Remove the top cover by pulling upwards on R2’s head.

Remove the top cover by pulling upwards on R2’s head.

1024

Step 2

Remove the dial in the front of the device by pulling the dial outwards.

Remove the dial in the front of the device by pulling the dial outwards.

Step 3

Remove the water tank by lifting the tank upwards.

Remove the water tank by lifting the tank upwards.

Step 4

Lay the bottom part of the device upside down on a table.
Locate the four PH1 screw heads on the underside.
We used the driver and 150mm driver extension with a PH1 screwdriver bit (from 64 Bit Driver Kit) to elongate the driver. (See note below and second image)
NOTE: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is at most 1cm in diameter and at least 5cm in depth.

Lay the bottom part of the device upside down on a table.

Locate the four PH1 screw heads on the underside.

We used the driver and 150mm driver extension with a PH1 screwdriver bit (from 64 Bit Driver Kit) to elongate the driver. (See note below and second image)

NOTE: The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is at most 1cm in diameter and at least 5cm in depth.

Step 5

Remove the blue reservoir cover by pulling up the extended plastic.

Remove the blue reservoir cover by pulling up the extended plastic.

Step 6

On the underside of the blue top, you should be able to see the LED exposed under the dial.

On the underside of the blue top, you should be able to see the LED exposed under the dial.

Step 7

To remove the blue LED, carefully pull the LED through the holes on the connector.
To add the new LED, make sure to connect the longer metal side (positive end) to the red side on the connector (positive end). The shorter end (negative side) should be connected to the black wire (negative side).
Once the LED is in and to make sure the LED stays connected, bend the metal ends at least 90 degrees to prevent it from sliding out of the connector.

To remove the blue LED, carefully pull the LED through the holes on the connector.

To add the new LED, make sure to connect the longer metal side (positive end) to the red side on the connector (positive end). The shorter end (negative side) should be connected to the black wire (negative side).

Once the LED is in and to make sure the LED stays connected, bend the metal ends at least 90 degrees to prevent it from sliding out of the connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors

                    Mani Jaishanker

Member since: 02/15/2017

228 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 8-5, Eyestone Spring 2017                        

                                                  Member of USF Tampa, Team 8-5, Eyestone Spring 2017 



                    USFT-EYESTONE-S17S8G5                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team