Difficulty

Moderate

Steps

7

Time Required

                          6 - 10 minutes

Sections

1

  • Fan
  • 7 steps

Flags

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackEmson Star Wars R2-D2 Humidifier

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Fan
  • Remove the top cover of the humidifier by pulling upwards.

Remove the top cover of the humidifier by pulling upwards.

1024

Step 2

  • Grip the dial from the front of the device and gently pull it away to remove it.

Grip the dial from the front of the device and gently pull it away to remove it.

Step 3

  • Remove the blue water tank of the humidifier by pulling upwards.

Remove the blue water tank of the humidifier by pulling upwards.

Step 4

  • Use a PH1 screwdriver bit and 150mm extension to unscrew the four screws from the bottom cover.

Use a PH1 screwdriver bit and 150mm extension to unscrew the four screws from the bottom cover.

Step 5

  • Remove the blue plastic top by pulling upwards on the middle notch.

Remove the blue plastic top by pulling upwards on the middle notch.

Step 6

  • This is where the fan is located. Carefully remove the fan from its compartment.
  • At this stage, you may remove the pin connector of the fan from the printed circuit board. However, it may be difficult to pull the pin. We recommend removing the printed circuit board for more clearance during removal.
  • Remove the screws on the printed circuit board using the same PH1 driver.

This is where the fan is located. Carefully remove the fan from its compartment.

At this stage, you may remove the pin connector of the fan from the printed circuit board. However, it may be difficult to pull the pin. We recommend removing the printed circuit board for more clearance during removal.

Remove the screws on the printed circuit board using the same PH1 driver.

Step 7

  • Grip the fan’s connector located on the printed circuit board and pull it away from the connector (see second picture).

Grip the fan’s connector located on the printed circuit board and pull it away from the connector (see second picture).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 4 other contributors 


                    Yash Chari

Member since: 02/15/2017

234 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 8-5, Eyestone Spring 2017                        

                                                  Member of USF Tampa, Team 8-5, Eyestone Spring 2017 



                    USFT-EYESTONE-S17S8G5                     


                                            4 Members                     


                                            5 Guides authored