Difficulty
Difficult
Steps
4
Time Required
20 minutes
Sections
2
- Back Plate
- 2 steps
- Speaker
- 2 steps
Flags
0
BackEmerson EM744
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Plate
- Use a Phillips 00 bit to remove two 3mm screws from the bottom of the tablet.
Use a Phillips 00 bit to remove two 3mm screws from the bottom of the tablet.
1024
Step 2
- Insert the nylon spudger into the bottom of the tablet, and gently slide it up the side.
- Pull apart the two sides of the tablet, exposing the circuit board, battery, and other components of the tablet.
Insert the nylon spudger into the bottom of the tablet, and gently slide it up the side.
Pull apart the two sides of the tablet, exposing the circuit board, battery, and other components of the tablet.
Step 3
Speaker
- Using tweezers, carefully remove the tape covering the speaker.
Using tweezers, carefully remove the tape covering the speaker.
Step 4
- Desolder the negative (black) wire from the negative (-) lead, followed by desoldering the positive (red) wire from the positive (+) lead.
- Refer to the soldering technique guide.
Desolder the negative (black) wire from the negative (-) lead, followed by desoldering the positive (red) wire from the positive (+) lead.
Refer to the soldering technique guide.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Matthew Maxfield
Member since: 09/15/2016
170 Reputation
1 Guide authored
Badges:
10
+7 more badges
Team
USF Tampa, Team 2-5, Blackwell Fall 2016
Member of USF Tampa, Team 2-5, Blackwell Fall 2016
USFT-BLACKWELL-F16S2G5
4 Members
12 Guides authored