Ematic Genesis Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Ematic Genesis Casing
3 steps
Camera
3 steps

Flags

BackEmatic Genesis
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Ematic Genesis Casing

Unscrew the two (2) 1.3mm Phillips #00 screws found on the bottom edge of the tablet, where the power and volume buttons are located.

Unscrew the two (2) 1.3mm Phillips #00 screws found on the bottom edge of the tablet, where the power and volume buttons are located.

1024

Step 2

Insert plastic opening tool into the edge between the screen plate and the back plate to create a separation between the casings.
Insert the flat end of the spudger next to the plastic opening tool and carefully pry the edges apart. Continue this all around the edges until the casings separate.
There may be cracking sounds when prying them apart. If carefully done, this is only the locks coming apart and is not harmful.
Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Insert plastic opening tool into the edge between the screen plate and the back plate to create a separation between the casings.

Insert the flat end of the spudger next to the plastic opening tool and carefully pry the edges apart. Continue this all around the edges until the casings separate.

There may be cracking sounds when prying them apart. If carefully done, this is only the locks coming apart and is not harmful.

Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Step 3

Remove back plate from screen plate and lay both down flat next to each other.
Be careful when separating the two plates as they are connected by the speaker wires and could be disconnected during this process.

Remove back plate from screen plate and lay both down flat next to each other.

Step 4

              Camera

Once the panels are separated, remove the tape holding down the ribbon connector that is connecting the camera to the motherboard.

Once the panels are separated, remove the tape holding down the ribbon connector that is connecting the camera to the motherboard.

Step 5

Lift up the black lever of the connector that holds the camera ribbon in place.

Lift up the black lever of the connector that holds the camera ribbon in place.

Step 6

Gently pull the ribbon out of the connector and lift the camera out of the casing.
There is adhesive holding the camera in the case. Pull up strong enough to separate the camera from the casing without damaging the components.

Gently pull the ribbon out of the connector and lift the camera out of the casing.

There is adhesive holding the camera in the case. Pull up strong enough to separate the camera from the casing without damaging the components.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Justin Rohrman

Member since: 03/23/2015

745 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Baylor, Team 4-3, Williams Spring 2015                        

                                                  Member of Baylor, Team 4-3, Williams Spring 2015 



                    BU-WILLIAMS-S15S4G3                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team