Ematic Funtab Ftabxxx Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

5

Time Required

                          30 minutes            

Sections

1

• Speaker
• 5 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

• BackEmatic Funtab FTABXXX

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Opening the Device               

• First, be sure to power off the device.
• Carefully pry open the device. Note the plastic tabs in the image that hold the device together.

First, be sure to power off the device.

Carefully pry open the device. Note the plastic tabs in the image that hold the device together.

1024

Step 2

              Locating the speaker               

• Locate the speaker in the bottom right hand side of the device. Note the red and black wires attaching the speaker to the motherboard.

Locate the speaker in the bottom right hand side of the device. Note the red and black wires attaching the speaker to the motherboard.

Step 3

              Removing the old speaker               

• Carefully remove the soldered wires from the motherboard. Note the positive and negative symbol where the red and black wires are soldered to on the motherboard.

Carefully remove the soldered wires from the motherboard. Note the positive and negative symbol where the red and black wires are soldered to on the motherboard.

Step 4

              Soldering the new speaker               

• Carefully, solder the new speaker wires to the motherboard in the same fashion as the old speaker. The red wire to the ‘+’ symbol and the black wire to the ‘-’ symbol.

Carefully, solder the new speaker wires to the motherboard in the same fashion as the old speaker. The red wire to the ‘+’ symbol and the black wire to the ‘-’ symbol.

Step 5

              Positioning the speaker               

• Once the solder points have cooled, position the speaker into the speaker housing on the back bezel as shown in the image.

Once the solder points have cooled, position the speaker into the speaker housing on the back bezel as shown in the image.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Robert Zarobinski                     

Member since: 01/21/2015

269 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       USF Tampa, Team 6-3, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 6-3, Brown Winter 2015 



                    USFT-BROWN-W15S6G3                     


                                            3 Members                     


                                            10 Guides authored