Difficulty

Difficult

Steps

6

Time Required

                          40 minutes

Sections

1

  • Battery
  • 6 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackEmatic Funtab FTABXXX

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • First, be sure to power off the device.
  • Carefully pry open the device. Note the plastic tabs in the image that hold the device together.

First, be sure to power off the device.

Carefully pry open the device. Note the plastic tabs in the image that hold the device together.

1024

Step 2

  • Locate the battery. Generally located in the middle of the device.

Locate the battery. Generally located in the middle of the device.

Step 3

  • Carefully pry off the battery from the display screen. This will be slight difficult since the battery is held onto the back of the display by adhesive.

Carefully pry off the battery from the display screen. This will be slight difficult since the battery is held onto the back of the display by adhesive.

Step 4

  • Locate the red and black wire that runs from the battery and to the motherboard. Note the location of the wires, and carefully remove the soldered wires.

Locate the red and black wire that runs from the battery and to the motherboard. Note the location of the wires, and carefully remove the soldered wires.

Step 5

  • Attach the new battery to the same location as the old battery via adhesive.
  • Then, carefully solder the red wire to the ‘+’ symbol on the motherboard and the black wire to the ‘-’ symbol.

Attach the new battery to the same location as the old battery via adhesive.

Then, carefully solder the red wire to the ‘+’ symbol on the motherboard and the black wire to the ‘-’ symbol.

Step 6

  • Once the solder has cooled, snap the front and back bezels together. Be sure to charge the new battery.

Once the solder has cooled, snap the front and back bezels together. Be sure to charge the new battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Robert Zarobinski

Member since: 01/21/2015

269 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 6-3, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 6-3, Brown Winter 2015 



                    USFT-BROWN-W15S6G3                     


                                            3 Members                     


                                            10 Guides authored