Difficulty
Moderate
Steps
8
Time Required
25 - 40 minutes
Sections
3
- Back Panel
- 2 steps
- Motherboard
- 4 steps
- Touch Screen
- 2 steps
Flags
0
BackEmatic FunTab 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Turn off the device before starting
- To prevent damage, open the device on the side without the buttons.
- Insert the hooked end of the plastic opening tool in the gap between the screen and the back panel on the edge of the device.
- Slide the plastic opening tool down the long side of the device.
- Insert tool again and slide it down the long slide of the case a second time.
Turn off the device before starting
To prevent damage, open the device on the side without the buttons.
Insert the hooked end of the plastic opening tool in the gap between the screen and the back panel on the edge of the device.
Slide the plastic opening tool down the long side of the device.
Insert tool again and slide it down the long slide of the case a second time.
1024
Step 2
- Pull the back panel away from the screen.
Pull the back panel away from the screen.
Step 3
Motherboard
- Remove the black tape to reveal the screen connector.
Remove the black tape to reveal the screen connector.
Step 4
- Flip up the retaining tab using the plastic opening tool.
- Pull out the screen wire ribbon to disconnect the screen and motherboard.
Flip up the retaining tab using the plastic opening tool.
Pull out the screen wire ribbon to disconnect the screen and motherboard.
Step 5
- Using a PH 00 screwdriver, remove the four 4.5 mm screws that are holding the motherboard in place.
Using a PH 00 screwdriver, remove the four 4.5 mm screws that are holding the motherboard in place.
Step 6
- It is now safe to remove and replace the old motherboard with your new motherboard.
- Close the black ribbon retaining tabs once ribbons are inserted during reassembly.
It is now safe to remove and replace the old motherboard with your new motherboard.
Close the black ribbon retaining tabs once ribbons are inserted during reassembly.
Step 7
Touch Screen
- Insert the hook side of the opening tool between the case and display.
- Press down on the tool until the screen is clear of the white retaining tabs.
- Use the plastic opening tool to gently pry up the screen.
- This is best done on the corner closest to the wire ribbon.
- Continue prying around the screen until the screen pops out.
Insert the hook side of the opening tool between the case and display.
Press down on the tool until the screen is clear of the white retaining tabs.
Use the plastic opening tool to gently pry up the screen.
This is best done on the corner closest to the wire ribbon.
Continue prying around the screen until the screen pops out.
Step 8
- After the screen has come lose, remove it from the device.
- When reassembling, make sure the screen locks in place, this may require extra pressure
- Close the black ribbon retaining tabs once ribbons are inserted during reassembly.
After the screen has come lose, remove it from the device.
When reassembling, make sure the screen locks in place, this may require extra pressure
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Amanda Davis
Member since: 07/11/2018
581 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
UW Tacoma, Team S1-G5, Cardinal Summer 2018
Member of UW Tacoma, Team S1-G5, Cardinal Summer 2018
UWT-CARDINAL-SU18S1G5
4 Members
12 Guides authored
DanTheMan RBLX - Sep 6, 2021
Reply
Where can I get a new display for my emoticons funtab 3?
