Ematic Funtab 3 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 30 minutes

Sections

Back Panel
2 steps
Battery
4 steps

Flags

BackEmatic FunTab 3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Turn off the device before starting
To prevent damage, open the device on the side without the buttons.
Insert the hooked end of the plastic opening tool in the gap between the screen and the back panel on the edge of the device.
Slide the plastic opening tool down the long side of the device.
Insert tool again and slide it down the long slide of the case a second time.

Turn off the device before starting

To prevent damage, open the device on the side without the buttons.

Insert the hooked end of the plastic opening tool in the gap between the screen and the back panel on the edge of the device.

Slide the plastic opening tool down the long side of the device.

Insert tool again and slide it down the long slide of the case a second time.

1024

Step 2

Pull the back panel away from the screen.

Pull the back panel away from the screen.

Step 3

              Battery

Remove the black tape to reveal the wire ribbon connector.

Remove the black tape to reveal the wire ribbon connector.

Step 4

Flip up the black retaining tab using the plastic opening tool.
Pull out the large wire ribbon that crosses over the battery.
You may need tweezers to pull out the wire ribbon.

Flip up the black retaining tab using the plastic opening tool.

Pull out the large wire ribbon that crosses over the battery.

You may need tweezers to pull out the wire ribbon.

Step 5

Insert the plastic opening tool under the battery.
Using the plastic opening tool, pry up the battery.
There is tape on the back of the battery. Some more force may be required to separate the battery from the back of the display.

Insert the plastic opening tool under the battery.

Using the plastic opening tool, pry up the battery.

There is tape on the back of the battery. Some more force may be required to separate the battery from the back of the display.

Step 6

Remove the wires from the motherboard using a soldering iron tool. Here is a link on How To Solder and Desolder Connections.
After the connections are desoldered, remove the battery.
Close the black ribbon retaining tabs once ribbons are inserted during reassembly.

Remove the wires from the motherboard using a soldering iron tool. Here is a link on How To Solder and Desolder Connections.

After the connections are desoldered, remove the battery.

Close the black ribbon retaining tabs once ribbons are inserted during reassembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Amanda Davis

Member since: 07/11/2018

581 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UW Tacoma, Team S1-G5, Cardinal Summer 2018                        

                                                  Member of UW Tacoma, Team S1-G5, Cardinal Summer 2018 



                    UWT-CARDINAL-SU18S1G5                     


                                            4 Members                     


                                            12 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team