Ematic Egq307 Front Facing Camera Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Front Facing Camera
5 steps

Flags

BackEmatic EGQ307
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Facing Camera

There are two screws on the side with the micro USB power port. Remove the two 2mm x 0.5mm screws with a Phillips #0 Screwdriver head.

There are two screws on the side with the micro USB power port. Remove the two 2mm x 0.5mm screws with a Phillips #0 Screwdriver head.

1024

Step 2

Pry off the plastic backing with the spudger and the plastic opening tools. Anything that can provide enough leverage and not conduct electricity will also work for this purpose.
Carefully separate the front and back plates because the wire that connects the speaker is connected to both the front and back plates.

Pry off the plastic backing with the spudger and the plastic opening tools. Anything that can provide enough leverage and not conduct electricity will also work for this purpose.

Carefully separate the front and back plates because the wire that connects the speaker is connected to both the front and back plates.

Step 3

Once you pry off the plastic backing, you will expose the battery and the motherboard.
Carefully separate the front and back plates because the wire that connects the speaker is connected to both the front and back plates.

Once you pry off the plastic backing, you will expose the battery and the motherboard.

Step 4

carefully pry off the plastic backing, remove the tape over the camera.
When working with device, make sure the battery is dead and there is not plugged in to the charger to limit the risk of shock.

carefully pry off the plastic backing, remove the tape over the camera.

When working with device, make sure the battery is dead and there is not plugged in to the charger to limit the risk of shock.

Step 5

Carefully remove the tape holding the camera in place as the camera is attached to the backing of the tape.
Gently lift up the black lever that’s holding the camera ribbon in place using the spudger tools.
Once lever is lifted up, remove camera from device; and it is ready to be replaced.

Carefully remove the tape holding the camera in place as the camera is attached to the backing of the tape.

Gently lift up the black lever that’s holding the camera ribbon in place using the spudger tools.

Once lever is lifted up, remove camera from device; and it is ready to be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Jonathan Scinto

Member since: 07/21/2015

530 Reputation

                                      4 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Eastern Washington University, Team 1-1, Rowley SU 2015                        

                                                  Member of Eastern Washington University, Team 1-1, Rowley SU 2015 



                    EWU-ROWLEY-SU15S1G1                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team