Difficulty
Moderate
Steps
6
Time Required
15 - 20 minutes
Sections
1
- Digitizer
- 6 steps
Flags
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
BackEmatic EGQ307
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Digitizer
- There are two screws on the side with the micro USB power port. Remove the two 2mm x 0.5mm screws with a Phillips #0 Screwdriver head.
There are two screws on the side with the micro USB power port. Remove the two 2mm x 0.5mm screws with a Phillips #0 Screwdriver head.
1024
Step 2
- Pry off the plastic backing with the spudger and the plastic opening tools. Anything that can provide enough leverage and not conduct electricity will also work for this purpose.
- Carefully separate the front and back plates because the wire that connects the speaker is connected to both the front and back plates.
Pry off the plastic backing with the spudger and the plastic opening tools. Anything that can provide enough leverage and not conduct electricity will also work for this purpose.
Carefully separate the front and back plates because the wire that connects the speaker is connected to both the front and back plates.
Step 3
- Once you pry off the plastic backing, you will expose the battery and the motherboard.
- Remove the tape holding the battery to the plastic frame. The battery is glued to the back of the LCD.
- Pry the battery off the LCD using a flat and rigid piece of plastic, such as the plastic card.
Once you pry off the plastic backing, you will expose the battery and the motherboard.
Remove the tape holding the battery to the plastic frame. The battery is glued to the back of the LCD.
Pry the battery off the LCD using a flat and rigid piece of plastic, such as the plastic card.
Step 4
- Carefully remove the tape holding the camera in place as the camera is attached to the backing of the tape.
- Gently lift up the black lever that’s holding the camera ribbon in place using a long piece of stiff plastic.
- Now, remove the camera from the device.
Carefully remove the tape holding the camera in place as the camera is attached to the backing of the tape.
Gently lift up the black lever that’s holding the camera ribbon in place using a long piece of stiff plastic.
Now, remove the camera from the device.
Step 5
- Remove the three 2mm x 0.5mm screws with a Phillips #0 Screwdriver head from the motherboard.
- Carefully remove the motherboard from the LCD backing. Remove tape from the edges of the LCD.
- Carefully pry off the LCD with a piece of plastic.
- Carefully remove the motherboard, battery, and the speaker, so wires do not get disconnected.
Remove the three 2mm x 0.5mm screws with a Phillips #0 Screwdriver head from the motherboard.
Carefully remove the motherboard from the LCD backing. Remove tape from the edges of the LCD.
Carefully pry off the LCD with a piece of plastic.
Carefully remove the motherboard, battery, and the speaker, so wires do not get disconnected.
Step 6
- Now Protective Screen is removed and is ready to be replaced.
Now Protective Screen is removed and is ready to be replaced.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Jonathan Scinto
Member since: 07/21/2015
530 Reputation
4 Guides authored
Badges:
13
+10 more badges
Team
Eastern Washington University, Team 1-1, Rowley SU 2015
Member of Eastern Washington University, Team 1-1, Rowley SU 2015
EWU-ROWLEY-SU15S1G1
4 Members
10 Guides authored
