Difficulty
Moderate
Steps
3
Time Required
5 seconds
Sections
2
- Back Cover Replacement Guide
- 2 steps
- Battery
- 1 step
Flags
0
BackElement GC-1020
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover Replacement Guide
- Unscrew the four screws (size: 3.175mm) on the left and right side of the Element Electronics GC-1020 device using the PH#0 screwdriver.
Unscrew the four screws (size: 3.175mm) on the left and right side of the Element Electronics GC-1020 device using the PH#0 screwdriver.
1024
Step 2
- Carefully pull the back of the device (the silver portion) apart from the rest of the device.
- If you pull back too forcefully the power button would move out of place.
Carefully pull the back of the device (the silver portion) apart from the rest of the device.
If you pull back too forcefully the power button would move out of place.
Step 3
Battery
- Then remove the battery from the device through soldering the black and red wires connected to the motherboard.
- This replacement will require a soldering station.
- To find out more on soldering refer to the Soldering and Desolder page to help you through this process.
Then remove the battery from the device through soldering the black and red wires connected to the motherboard.
This replacement will require a soldering station.
To find out more on soldering refer to the Soldering and Desolder page to help you through this process.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Lashaun Noel
Member since: 09/25/2015
591 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
University of Tampa, Team 1-4, Whiteside Fall 2015
Member of University of Tampa, Team 1-4, Whiteside Fall 2015
UT-WHITESIDE-F15S1G4
4 Members
5 Guides authored