Difficulty
Moderate
Steps
9
Time Required
5 - 10 minutes
Sections
3
- Battery
- 2 steps
- Buttons
- 3 steps
- Speaker
- 4 steps
Flags
1
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
BackElectrohome EAAC475
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the 10 mm Phillips #1 screw from the battery cover.
- Remove the battery cover.
Remove the 10 mm Phillips #1 screw from the battery cover.
Remove the battery cover.
1024
Step 2
- Remove the flat lithium battery.
Remove the flat lithium battery.
Step 3
Buttons
- Disconnect the radio from all power sources.
- Remove the two 10 mm Phillips #1 screws from the bottom of the device.
- Remove two 10 mm Phillips #1 screws from the back side of the device.
Disconnect the radio from all power sources.
Remove the two 10 mm Phillips #1 screws from the bottom of the device.
Remove two 10 mm Phillips #1 screws from the back side of the device.
Step 4
- Carefully and slowly pull the lower case away from the rest of the device.
- Do not completely separate the lower case. There are several wires connecting the two halves of the device.
- Flip the device over to access the button assembly.
- Slowly remove the button contact board from the assembly.
Carefully and slowly pull the lower case away from the rest of the device.
Do not completely separate the lower case. There are several wires connecting the two halves of the device.
Flip the device over to access the button assembly.
Slowly remove the button contact board from the assembly.
Step 5
- Remove the two 7 mm Phillips # 1 screws holding the buttons.
- Remove the plastic buttons.
Remove the two 7 mm Phillips # 1 screws holding the buttons.
Remove the plastic buttons.
Step 6
Speaker
- Carefully and slowly detach one side from another.
- Make sure the opposite sides are not separated completely.
- Locate the speaker the inside of the back piece of the device
Carefully and slowly detach one side from another.
Make sure the opposite sides are not separated completely.
Locate the speaker the inside of the back piece of the device
Step 7
- Use the flat side of the spudger to remove the glue around the speaker.
- This glue will need replacing when putting back the speaker.
Use the flat side of the spudger to remove the glue around the speaker.
This glue will need replacing when putting back the speaker.
Step 8
- After removing all the glue around the speaker, slowly take out the speaker.
- Be careful not to break anything surrounding the speaker while using the spudger since it is sharp.
After removing all the glue around the speaker, slowly take out the speaker.
Be careful not to break anything surrounding the speaker while using the spudger since it is sharp.
Step 9
- Detach the wires on the speaker and replace them with new ones.
Detach the wires on the speaker and replace them with new ones.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Ruolin Cai
Member since: 02/16/2016
261 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
IUPUI, Team 2-1, Harley Spring 2016
Member of IUPUI, Team 2-1, Harley Spring 2016
IUPUI-HARLEY-S16S2G1
4 Members
6 Guides authored
