Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
2
- Battery
- 2 steps
- Projector Lens
- 7 steps
Flags
0
BackElectrohome EAAC475
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the 10 mm Phillips #1 screw from the battery cover.
- Remove the battery cover.
Remove the 10 mm Phillips #1 screw from the battery cover.
Remove the battery cover.
1024
Step 2
- Remove the flat lithium battery.
Remove the flat lithium battery.
Step 3
Projector Lens
- Slowly and carefully move one side away from another without detaching anything on the device.
Slowly and carefully move one side away from another without detaching anything on the device.
Step 4
- Detach the projector.
Detach the projector.
Step 5
- Unplug the projector’s connector from the circuit board.
Unplug the projector’s connector from the circuit board.
Step 6
- Take off the rubber ring.
Take off the rubber ring.
Step 7
- Using a metal spudger, pry into the crease until it separates enough to slip the spudger between the pieces.
- Slide the tool along the crease to separate.
Using a metal spudger, pry into the crease until it separates enough to slip the spudger between the pieces.
Slide the tool along the crease to separate.
Step 8
- Take the lens out of the projector.
Take the lens out of the projector.
Step 9
- Separate the lens and the gear by unscrewing the gear.
Separate the lens and the gear by unscrewing the gear.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Sterling Fulk
Member since: 02/16/2016
258 Reputation
2 Guides authored
Badges:
12
+9 more badges
Team
IUPUI, Team 2-1, Harley Spring 2016
Member of IUPUI, Team 2-1, Harley Spring 2016
IUPUI-HARLEY-S16S2G1
4 Members
6 Guides authored
