Difficulty

Easy

Steps

9

Time Required

                          20 minutes

Sections

1

  • EK3211 Kitchen Scale Disassembly
  • 9 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackEK3211 Kitchen Scale

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove label to access screws
  • Peel back the “ELECTRONIC KITCHEN SCALE” label to reveal two screws underneath.

Peel back the “ELECTRONIC KITCHEN SCALE” label to reveal two screws underneath.

1024

Step 2

  • Use a #2 Phillips screwdriver to remove the two screws.
  • These screws are very tight and prone to strip.

Use a #2 Phillips screwdriver to remove the two screws.

These screws are very tight and prone to strip.

Step 3

  • Remove the four screws holding the top veneer panel to the base.

Remove the four screws holding the top veneer panel to the base.

Step 4

  • Remove the top veneer panel. It should come off without any force.
  • There are two small plastic clips on the edge below the screen, which must be inserted correctly during reassembly.

Remove the top veneer panel. It should come off without any force.

There are two small plastic clips on the edge below the screen, which must be inserted correctly during reassembly.

Step 5

  • Remove the screw holding the PCB and screen in place using a #1 Phillips screwdriver.

Remove the screw holding the PCB and screen in place using a #1 Phillips screwdriver.

Step 6

  • Remove the PCB and screen assembly.
  • The buttons should also lift up with the rest of the PCB/screen assembly.

Remove the PCB and screen assembly.

The buttons should also lift up with the rest of the PCB/screen assembly.

Step 7

  • Use a #1 Phillips screwdriver to remove the four screws holding the load cell mount to the base.

Use a #1 Phillips screwdriver to remove the four screws holding the load cell mount to the base.

Step 8

  • Remove the two screws holding the load cell to the bracket using a #2 Phillips screwdriver.

Remove the two screws holding the load cell to the bracket using a #2 Phillips screwdriver.

Step 9

  • Separate the bracket from the load cell.
  • Be careful not to lose the spacer plate.

Separate the bracket from the load cell.

Be careful not to lose the spacer plate.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Steven Bell

Member since: 08/27/2020

194 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge