Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Logic Board
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackEightarc Fusion

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Logic Board
  • Because of the protruding joystick on the top of the controller, make sure to work on a soft surface or prop the controller up to avoid stress on the joystick.
  • Place the controller face down (buttons and joystick down).
  • Use a Phillips Head #1 screwdriver to remove the eight 9.65mm screws located on the felt and metal backplate.
  • Do not confuse the four screws in the rubber feet with the eight screws in the felt. The screws in the feet do not need to be removed.

Because of the protruding joystick on the top of the controller, make sure to work on a soft surface or prop the controller up to avoid stress on the joystick.

Place the controller face down (buttons and joystick down).

Use a Phillips Head #1 screwdriver to remove the eight 9.65mm screws located on the felt and metal backplate.

Do not confuse the four screws in the rubber feet with the eight screws in the felt. The screws in the feet do not need to be removed.

1024

Step 2

  • Open the door for the cord storage compartment on the right side of the device.
  • Reach under the panel and push upwards on the back panel. Lift it up and remove it from the device.

Open the door for the cord storage compartment on the right side of the device.

Reach under the panel and push upwards on the back panel. Lift it up and remove it from the device.

Step 3

  • Make sure not to flex the logic board when removing ribbon cables.
  • Individually remove the seven cable connectors plugged into the logic board by grasping each white plug and gently pulling upwards.

Make sure not to flex the logic board when removing ribbon cables.

Individually remove the seven cable connectors plugged into the logic board by grasping each white plug and gently pulling upwards.

Step 4

  • Use a Phillips Head #1 screwdriver to remove the two 7.15mm washer head screws from logic board.

Use a Phillips Head #1 screwdriver to remove the two 7.15mm washer head screws from logic board.

Step 5

  • Gently lift off logic board up to remove from the device.

Gently lift off logic board up to remove from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Chandler Stalford

Member since: 02/04/2015

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team 17-35, Amido Winter 2015                        

                                                  Member of Cal Poly, Team 17-35, Amido Winter 2015 



                    CPSU-AMIDO-W15S17G35                     


                                            4 Members                     


                                            5 Guides authored