Eightarc Fusion Headphone Jack Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Headphone Jack
5 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

BackEightarc Fusion
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Warning: Use caution when placing the joystick face down on the table. The joystick can crack if placed down too hard. Be sure to gently turn the device over and place it face down. It can be helpful to balance the other side of the device to distribute the weight.

What you need

Step 1

              Headphone Jack

Because of the protruding joystick on the top of the controller, make sure to work on a soft surface or prop the controller up to avoid stress on the joystick.
Place the controller face down (buttons and joystick down).
Use a Phillips Head #1 screwdriver to remove the eight 9.65mm screws located on the felt and metal backplate.
Do not confuse the four screws in the rubber feet with the eight screws in the felt. The screws in the feet do not need to be removed.

Because of the protruding joystick on the top of the controller, make sure to work on a soft surface or prop the controller up to avoid stress on the joystick.

Place the controller face down (buttons and joystick down).

Use a Phillips Head #1 screwdriver to remove the eight 9.65mm screws located on the felt and metal backplate.

Do not confuse the four screws in the rubber feet with the eight screws in the felt. The screws in the feet do not need to be removed.

1024

Step 2

Open the door for the cord storage compartment on the right side of the device.
Reach under the panel and push upwards on the back panel. Lift it up and remove it from the device.

Open the door for the cord storage compartment on the right side of the device.

Reach under the panel and push upwards on the back panel. Lift it up and remove it from the device.

Step 3

Grasp the white plug connecting the wires to the headphone jack, and pull gently upwards.

Grasp the white plug connecting the wires to the headphone jack, and pull gently upwards.

Step 4

Using a Phillips head #1 screwdriver, remove the two washer head screws from the headphone jack.

Using a Phillips head #1 screwdriver, remove the two washer head screws from the headphone jack.

Step 5

Gently wiggle the headphone jack left and right, pulling it towards you until it slides out of the hole in the enclosure.

Gently wiggle the headphone jack left and right, pulling it towards you until it slides out of the hole in the enclosure.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Christopher

Member since: 01/29/2015

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Cal Poly, Team 17-35, Amido Winter 2015                        

                                                  Member of Cal Poly, Team 17-35, Amido Winter 2015 



                    CPSU-AMIDO-W15S17G35                     


                                            4 Members                     


                                            5 Guides authored

Slice and Dice#

Introduction#

What you need#

Team#

Slice and Dice

Introduction

What you need

Team