Difficulty

Moderate

Steps

7

Time Required

                          10 - 30 minutes

Sections

2

  • Safety Precautions
  • 1 step
  • Belt
  • 6 steps

Flags

0

  • BackEDCO Floor Stripper TS8-.75L (2017)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions
  • Before you begin, ensure the device is powered down and cool to the touch.
  • Ensure the machine is unplugged.
  • Turn the power switch counterclockwise into the OFF position.

Before you begin, ensure the device is powered down and cool to the touch.

Ensure the machine is unplugged.

Turn the power switch counterclockwise into the OFF position.

1024

Step 2

              Remove the hood bolts
  • Use a 1/2 inch socket to remove the four bolts securing the hood to the frame, two on each side.
  • During reassembly, ensure each bolt is reinstalled with both its flat washer and lock washer.

Use a 1/2 inch socket to remove the four bolts securing the hood to the frame, two on each side.

During reassembly, ensure each bolt is reinstalled with both its flat washer and lock washer.

Step 3

              Remove the hood
  • Pull the hood away from the device to remove it.

Pull the hood away from the device to remove it.

Step 4

              Loosen the motor mount bolts
  • Use a 9/16 inch socket to loosen, but not remove, the four bolts securing the motor mount to the frame, two on each side.

Use a 9/16 inch socket to loosen, but not remove, the four bolts securing the motor mount to the frame, two on each side.

Step 5

              Slide motor mount forward
  • Slide the motor towards the front of the device to release tension in the belt."
  • Reassembly tip: Tilt the device onto its handles to use the weight of the motor to tension the belt, then tighten down the bolts.

Slide the motor towards the front of the device to release tension in the belt."

Reassembly tip: Tilt the device onto its handles to use the weight of the motor to tension the belt, then tighten down the bolts.

Step 6

              Remove the belt
  • Remove the belt from the cam shaft pulley.

Remove the belt from the cam shaft pulley.

Step 7

  • Disengage the belt from the motor pulley.
  • Remove the belt.

Disengage the belt from the motor pulley.

Remove the belt.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Robert Boyd

Member since: 02/01/2021

21,303 Reputation

                                      92 Guides authored                  



                       Badges:
                       19







                                                        +16 more badges