Ecovacs Deebot 900 Front Bumper Replacement Repair Guide

Difficulty

Very easy

Steps

9

Time Required

                          2 - 5 minutes            

Sections

2

• Battery
• 5 steps
• Front Bumper
• 4 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackEcovacs Deebot 900

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Remove all the brushes from the Deebot.

Remove all the brushes from the Deebot.

1024

Step 2

• Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

Step 3

• Remove the battery cover.

Remove the battery cover.

Step 4

• Using the two white straps on the sides of the battery, gently remove the battery. ​
• Be careful not to rip out the battery cable.

Using the two white straps on the sides of the battery, gently remove the battery. ​

Be careful not to rip out the battery cable.

Step 5

• Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

Step 6

              Front Bumper               

• Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

Step 7

• Remove the black strip on the bottom of the bumper.

Remove the black strip on the bottom of the bumper.

Step 8

• Carefully lift up the bumper untill it pops out of place.​

Carefully lift up the bumper untill it pops out of place.​

Step 9

• Disconnect the two cables connecting the bumper to the body of the Deebot.
• Remove the front bumper from the device.

Disconnect the two cables connecting the bumper to the body of the Deebot.

Remove the front bumper from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Gillian Blumer                     

Member since: 01/16/2020

492 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020 



                    ERAU-RAUCH-S20S6G1                     


                                            3 Members                     


                                            17 Guides authored                     

Chris Khacherian - Oct 15, 2021

Reply

Where may I buy the front bumper assembly? I’m trying to replace one for a deebot 901 but the mfg tells me they don’t see the part directly.