Ecovacs Deebot 900 Bottom Case Replacement Repair Guide

Difficulty

Moderate

Steps

11

Time Required

                          10 - 15 minutes            

Sections

3

• Battery
• 5 steps
• Front Bumper
• 4 steps
• Bottom Case
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackEcovacs Deebot 900

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Remove all the brushes from the Deebot.

Remove all the brushes from the Deebot.

1024

Step 2

• Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

Step 3

• Remove the battery cover.

Remove the battery cover.

Step 4

• Using the two white straps on the sides of the battery, gently remove the battery. ​
• Be careful not to rip out the battery cable.

Using the two white straps on the sides of the battery, gently remove the battery. ​

Be careful not to rip out the battery cable.

Step 5

• Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

Step 6

              Front Bumper               

• Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

Step 7

• Remove the black strip on the bottom of the bumper.

Remove the black strip on the bottom of the bumper.

Step 8

• Carefully lift up the bumper untill it pops out of place.​

Carefully lift up the bumper untill it pops out of place.​

Step 9

• Disconnect the two cables connecting the bumper to the body of the Deebot.
• Remove the front bumper from the device.

Disconnect the two cables connecting the bumper to the body of the Deebot.

Remove the front bumper from the device.

Step 10

              Bottom Case               

• Using a Phillips #00 screwdriver, take out the six screws around the perimeter of the bottom case.

Using a Phillips #00 screwdriver, take out the six screws around the perimeter of the bottom case.

Step 11

• Insert a Jimmy into the seam and work all the way around the robot.
• Disconnect the two cables and remove the bottom case from the device.

Insert a Jimmy into the seam and work all the way around the robot.

Disconnect the two cables and remove the bottom case from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Christina Corliss                     

Member since: 01/16/2020

661 Reputation

                                      3 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G1, Rauch Spring 2020 



                    ERAU-RAUCH-S20S6G1                     


                                            3 Members                     


                                            17 Guides authored