Difficulty
Moderate
Steps
7
Time Required
20 minutes
Sections
2
- Frame
- 4 steps
- Cone
- 3 steps
Flags
0
BackEco X Gear
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Frame
- Disconnect any power source and/or turn off device.
Disconnect any power source and/or turn off device.
1024
Step 2
- Remove the 15 rubber plugs from the cavities using needle nose pliers.
Remove the 15 rubber plugs from the cavities using needle nose pliers.
Step 3
- Use a phillips head screwdriver to remove the fifteen 6.4mm screws.
Use a phillips head screwdriver to remove the fifteen 6.4mm screws.
Step 4
- Carefully separate the two sections of the frame.
- Wires still connect the two sections. Be cautious to avoid damaging the wires, terminals, and electronics.
Carefully separate the two sections of the frame.
Wires still connect the two sections. Be cautious to avoid damaging the wires, terminals, and electronics.
Step 5
Cone
- Disconnect the wiring to improve accessibility to the cones.
Disconnect the wiring to improve accessibility to the cones.
Step 6
- Remove the four screws which hold down the speaker. Then, pry up the speaker from the frame.
Remove the four screws which hold down the speaker. Then, pry up the speaker from the frame.
Step 7
- To replace the cone, remove the existing one by peeling it off of the speaker with needle nose pliers.
To replace the cone, remove the existing one by peeling it off of the speaker with needle nose pliers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
James Lipsett
Member since: 03/20/2017
601 Reputation
6 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team S9-G3, Martin Spring 2017
Member of UMass Dartmouth, Team S9-G3, Martin Spring 2017
UMASSD-MARTIN-S17S9G3
2 Members
6 Guides authored
