Difficulty
Moderate
Steps
3
Time Required
5 - 10 minutes
Sections
1
- Neck Joint
- 3 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackUniversal EBK340 Wessel-Werk Electric Powerhead
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove Outer Cover
- Position the device so brushes are upwards and visible
- Unscrew the 6 outer screws. 2 on the edge of the brush crevice, and 4 nearer to the wheels.
- Turn over the device.
- Pull the cover off gently.
Position the device so brushes are upwards and visible
Unscrew the 6 outer screws. 2 on the edge of the brush crevice, and 4 nearer to the wheels.
Turn over the device.
Pull the cover off gently.
1024
Step 2
Remove Inner Cover
- Unscrew the 2 screws indicated, one visible, the other within a deep hole
- Gently pull off the cover. Careful not to torque the plastic teeth shown in orange.
Unscrew the 2 screws indicated, one visible, the other within a deep hole
Gently pull off the cover. Careful not to torque the plastic teeth shown in orange.
Step 3
Replace Neck Joint
- Gently lift the two LED lights upwards and away for the moment.
- Gently lift out the defective neck joint.
- Slide in the replacement joint.
- Replace the lights into the molded corners that hold their board.
Gently lift the two LED lights upwards and away for the moment.
Gently lift out the defective neck joint.
Slide in the replacement joint.
Replace the lights into the molded corners that hold their board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
FolsomMaids Office
Member since: 10/09/2019
167 Reputation
1 Guide authored
Badges:
3