Difficulty

Easy

Steps

11

Time Required

                          5 minutes

Sections

1

  • e-lite web150 Disassembly
  • 11 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackLeaf Blower

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              removing the blower nozzle
  • Firmly press the yellow button and slide the blower nozzle off.

Firmly press the yellow button and slide the blower nozzle off.

1024

Step 2

              un-screwing
  • un-screw all of the screws

un-screw all of the screws

Step 3

              opening
  • pull apart the 2 halves

pull apart the 2 halves

Step 4

              The inside
  • This is the inside of the blower

This is the inside of the blower

Step 5

              pulling out the switch and plug
  • gently pull out the power plug and switch

gently pull out the power plug and switch

Step 6

              removing the motor
  • gently pull out the motor paying attention to which side it came out of.

gently pull out the motor paying attention to which side it came out of.

Step 7

              putting the motor back in
  • clean the dust out if you need to. then carefully put the motor back in making sure you put both of the tabs on the motor into their respective slots. you can’t see the other one because I had to crop it out.

clean the dust out if you need to. then carefully put the motor back in making sure you put both of the tabs on the motor into their respective slots. you can’t see the other one because I had to crop it out.

Step 8

              putting the plugs back in their places
  • carefully put the plugs back into their holders.

carefully put the plugs back into their holders.

Step 9

              closing it up
  • fit the 2 halves back together

fit the 2 halves back together

Step 10

              screwing in the screws
  • replace all of the screws

replace all of the screws

Step 11

              re-attaching the blower nozzle
  • slide the blower nozzle on to the main body until it locks in place, you are done.

slide the blower nozzle on to the main body until it locks in place, you are done.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Alex Pollard

Member since: 11/07/2016

119 Reputation

                                      1 Guide authored                  



                       Badges:
                       3