Difficulty

Moderate

Steps

8

Time Required

                          5 - 7 minutes

Sections

2

  • Bin
  • 4 steps
  • Main Body
  • 4 steps

Flags

0

  • BackDyson v6 Absolute

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bin
  • Unplug the device.

Unplug the device.

1024

Step 2

  • Push down the red lever located on the outside of the bin, next to the device handle, to open the door to the debris bin.
  • Avoid pressing the trigger on the handle opposite the red lever, which activates the motor.

Push down the red lever located on the outside of the bin, next to the device handle, to open the door to the debris bin.

Avoid pressing the trigger on the handle opposite the red lever, which activates the motor.

Step 3

  • Push the red lever down a second time to release the debris bin.
  • Avoid pressing the trigger on the handle opposite the red lever, which activates the motor.

Push the red lever down a second time to release the debris bin.

Step 4

  • Pull bin away from the cyclone.

Pull bin away from the cyclone.

Step 5

              Main Body
  • Separate the bin from the main body of the device.

Separate the bin from the main body of the device.

Step 6

  • Locate two visible white clips between the main body and the cyclone.

Locate two visible white clips between the main body and the cyclone.

Step 7

  • Use tweezers to pinch the white clips together.
  • Widely hold the tweezers apart to get them to reach between the two white clips.
  • Because the space is tight between the cyclone and the main body, pinching the white clips may require additional effort.

Use tweezers to pinch the white clips together.

Widely hold the tweezers apart to get them to reach between the two white clips.

Because the space is tight between the cyclone and the main body, pinching the white clips may require additional effort.

Step 8

  • Tilt and pull the main body away from the cyclone.
  • There may be a loud snap when the main body separates from the cyclone.

Tilt and pull the main body away from the cyclone.

There may be a loud snap when the main body separates from the cyclone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      11 other people completed this guide.

Author

                                      with 2 other contributors 


                    Tabitha Espina Velasco

Member since: 01/23/2017

3,375 Reputation

                                      5 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Washington State, Team 1-2, Staggers Spring 2017                        

                                                  Member of Washington State, Team 1-2, Staggers Spring 2017 



                    WSU-STAGGERS-S17S1G2                     


                                            2 Members                     


                                            20 Guides authored

Robert Hoppe - Jan 2, 2022

Reply

The motorhead does not rotate or only works irregularly?

There are two little metal tabs sitting above the lever of the bin and are meant to make electrical contact to the wires running around the bin and down the wand to the motorhead to power the rotating brush. Those metal-tabs tend to get bend and/or their ends might have become dislocated out of their brackets.

Thanks for Your guide!!! It helped me to remove the Main Body from the Cyclone properly and get those metal-tabs back in place.