Difficulty

Moderate

Steps

10

Time Required

                          1 hour

Sections

1

  • Trigger
  • 10 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackDyson V11 Torque Drive

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Tools you will need to replace the trigger on the Dyson V11 Torque Drive vacuum are a Phillips #1 screw driver, Phillips #0 screw driver, and a spudger.

What you need

Step 1

              Trigger
  • Remove the four screws beside the battery indicator with a Phillips #1 screwdriver.

Remove the four screws beside the battery indicator with a Phillips #1 screwdriver.

1024

Step 2

  • Remove two screws next to the handle using a Phillips #1 screwdriver.

Remove two screws next to the handle using a Phillips #1 screwdriver.

Step 3

  • Separate the handle and the front end of the vacuum cleaner.

Separate the handle and the front end of the vacuum cleaner.

Step 4

  • Remove two screws from the protective case covering the circuit board using a Phillips #0 screwdriver.

Remove two screws from the protective case covering the circuit board using a Phillips #0 screwdriver.

Step 5

  • Take the plastic protective case off.

Take the plastic protective case off.

Step 6

  • Remove the single screw from the motherboard using a Phillips #1 screwdriver.

Remove the single screw from the motherboard using a Phillips #1 screwdriver.

Step 7

  • Remove the center part from the outer shell.

Remove the center part from the outer shell.

Step 8

  • Remove the single screw inside the charging compartment with a Phillips #0 screwdriver.

Remove the single screw inside the charging compartment with a Phillips #0 screwdriver.

Step 9

  • Remove two screws with a Phillips #0 screwdriver.

Remove two screws with a Phillips #0 screwdriver.

Step 10

  • Use a spudger to push the part marked in the image to remove the trigger from the charging compartment.

Use a spudger to push the part marked in the image to remove the trigger from the charging compartment.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Beicheng Zhu

Member since: 01/15/2022

205 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       York University, Team 1-29, O'Regan Winter 2022                        

                                                  Member of York University, Team 1-29, O'Regan Winter 2022 



                    YORK-O'REGAN-W22S1G29                     


                                            1 Member                     


                                            1 Guide authored