Dyson Supersonic Hd03 Hairdryer Filter Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          30 minutes

Sections

Filter
6 steps

Flags

BackHair Dryer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

For further detailed information, you can visit Dyson Official.

What you need

Step 1

              Filter

Unplug the hairdryer to avoid further hazard.

Unplug the hairdryer to avoid further hazard.

1024

Step 2

Remove the dirty filter cage by twisting the filter towards the left.
The filter cage will be unlocked when the red dot matches the white thin circle.
Do not run your hairdryer without a filter cage.

Remove the dirty filter cage by twisting the filter towards the left.

The filter cage will be unlocked when the red dot matches the white thin circle.

Do not run your hairdryer without a filter cage.

Step 3

Soak the filter cage in dish soap and warm water for at least 30 minutes.
You can leave the filter in for multiple hours or overnight if it’s especially dirty.

Soak the filter cage in dish soap and warm water for at least 30 minutes.

You can leave the filter in for multiple hours or overnight if it’s especially dirty.

Step 4

Use the supplied filter cleaning brush or any other cleaning tool to vigorously scrub the soaked filter cage.
Be sure to remove all blockages.

Use the supplied filter cleaning brush or any other cleaning tool to vigorously scrub the soaked filter cage.

Be sure to remove all blockages.

Step 5

Rinse and dry your filter cage.
Check that the filter cage is clean by holding it up to the light - you should be able to see light through it. If you can’t, repeat the previous step.

Rinse and dry your filter cage.

Check that the filter cage is clean by holding it up to the light - you should be able to see light through it. If you can’t, repeat the previous step.

Step 6

Insert the filter back into the filter cage and install the filter cage back onto the device.
The filter cage will be locked when the red dot matches the white filled circle.

Insert the filter back into the filter cage and install the filter cage back onto the device.

The filter cage will be locked when the red dot matches the white filled circle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Huan-Che Hsu

Member since: 09/18/2021

192 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       York University, Team F-14, Woodhouse Fall 2021                        

                                                  Member of York University, Team F-14, Woodhouse Fall 2021 



                    YORK-WOODHOUSE-F21SFG14                     


                                            1 Member                     


                                            1 Guide authored

Jimjar - Oct 14, 2022

My Dyson hair dryer has quitting every 30 seconds - apparently overheating. It was very easy to remove the filter cage and wipe the filter clean. Problem solved!

Introduction#

What you need#

Team#

Introduction

What you need

Team