Dyson Dc56 Cyclone Replacement Repair Guide

Difficulty

Moderate

Steps

11

Time Required

                          15 - 20 minutes            

Sections

2

• Dust Bin
• 7 steps
• Cyclone
• 4 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

• BackDyson DC56

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Dust Bin               

• Make sure the vacuum is unplugged.
• Warning: Avoid pressing the red trigger because it will turn on and begin suction.

Make sure the vacuum is unplugged.

Warning: Avoid pressing the red trigger because it will turn on and begin suction.

1024

Step 2

• Locate the purple button at the top of the device.

Locate the purple button at the top of the device.

Step 3

• Separate the device with the purple button.

Separate the device with the purple button.

Step 4

• Locate the dust bin’s red release lever on the side of the device.
• Make sure if the dust bin is full you open the vacuum over a trash can.

Locate the dust bin’s red release lever on the side of the device.

Make sure if the dust bin is full you open the vacuum over a trash can.

Step 5

• Push the red lever to release the dust bin lid.

Push the red lever to release the dust bin lid.

Step 6

• Locate the red lever below the vacuum.

Locate the red lever below the vacuum.

Step 7

• Push the red lever, pull the back up and away from the dust bin to separate them.

Push the red lever, pull the back up and away from the dust bin to separate them.

Step 8

              Cyclone               

• Use a T8-Torque screwdriver to remove the 18mm screw from the back of the Cyclone.

Use a T8-Torque screwdriver to remove the 18mm screw from the back of the Cyclone.

Step 9

• Remove the bottom of the cyclone screen by twisting it to the left and pulling down.

Remove the bottom of the cyclone screen by twisting it to the left and pulling down.

Step 10

• Remove the rest of the cyclone screen by pulling down.

Remove the rest of the cyclone screen by pulling down.

Step 11

• Locate and take out the six 26mm screws with a T-8 Torque screwdriver.
• Once you have removed the screws you can remove the rest of the Cyclone.

Locate and take out the six 26mm screws with a T-8 Torque screwdriver.

Once you have removed the screws you can remove the rest of the Cyclone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 4 other contributors 

                    John Czerkawski                     

Member since: 10/02/2017

421 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team S10-G1, Thompson Fall 2017                        

                                                  Member of USF Tampa, Team S10-G1, Thompson Fall 2017 



                    USFT-THOMPSON-F17S10G1                     


                                            4 Members                     


                                            11 Guides authored                     

J M - Dec 1, 2018

Reply

I can’t remove the cyclone screen. Any tricks to removing?