Difficulty

Moderate

Steps

11

Time Required

                          5 - 10 minutes

Sections

2

  • Dust Bin
  • 7 steps
  • Attachments
  • 4 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackDyson DC56

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Dust Bin
  • Make sure the vacuum is unplugged.
  • Warning: Avoid pressing the red trigger because it will turn on and begin suction.

Make sure the vacuum is unplugged.

Warning: Avoid pressing the red trigger because it will turn on and begin suction.

1024

Step 2

  • Locate the purple button at the top of the device.

Locate the purple button at the top of the device.

Step 3

  • Separate the device with the purple button.

Separate the device with the purple button.

Step 4

  • Locate the dust bin’s red release lever on the side of the device.
  • Make sure if the dust bin is full you open the vacuum over a trash can.

Locate the dust bin’s red release lever on the side of the device.

Make sure if the dust bin is full you open the vacuum over a trash can.

Step 5

  • Push the red lever to release the dust bin lid.

Push the red lever to release the dust bin lid.

Step 6

  • Locate the red lever below the vacuum.

Locate the red lever below the vacuum.

Step 7

  • Push the red lever, pull the back up and away from the dust bin to separate them.

Push the red lever, pull the back up and away from the dust bin to separate them.

Step 8

              Attachments
  • Locate two screws at the back of the attachment holder.

Locate two screws at the back of the attachment holder.

Step 9

  • Use a T8-Torque screwdriver to take out the two 26mm screws out.

Use a T8-Torque screwdriver to take out the two 26mm screws out.

Step 10

  • Loosen the attachment holder by using a metal spudger.

Loosen the attachment holder by using a metal spudger.

Step 11

  • Remove the attachment holder.

Remove the attachment holder.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    John Czerkawski

Member since: 10/02/2017

421 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team S10-G1, Thompson Fall 2017                        

                                                  Member of USF Tampa, Team S10-G1, Thompson Fall 2017 



                    USFT-THOMPSON-F17S10G1                     


                                            4 Members                     


                                            11 Guides authored