Dyson Dc39 Origin Steering Assembly Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Bin
1 step
Steering Assembly
2 steps

Flags

BackDyson DC39 Origin
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

Bin

Push down on the gray button located next to the power button to release the bin from the ball housing.
Pull the bin away, then up from the ball housing to remove it.
If the bin won’t fit back into place during re-assembly, you may need to push the grey button again.

Push down on the gray button located next to the power button to release the bin from the ball housing.

Pull the bin away, then up from the ball housing to remove it.

If the bin won’t fit back into place during re-assembly, you may need to push the grey button again.

1024

Step 2

              Steering Assembly

Place the ball housing on its side and orient it so that the underside of the steering assembly is facing you.
Remove the four 18.0 mm Torx 15 screws.

Place the ball housing on its side and orient it so that the underside of the steering assembly is facing you.

Remove the four 18.0 mm Torx 15 screws.

Step 3

Using two hands, hold the ball housing with the handle in one hand and the steering assembly base in the other.
Hold the steering assembly base near one of the wheels.
Pull the steering assembly base directly away from the ball housing. You should notice a pin release.
Push up on the steering assembly to remove it completely from the ball housing.
During reassembly, slide the steering assembly in first, then push the pin back into its locking position.

Using two hands, hold the ball housing with the handle in one hand and the steering assembly base in the other.

Hold the steering assembly base near one of the wheels.

Pull the steering assembly base directly away from the ball housing. You should notice a pin release.

Push up on the steering assembly to remove it completely from the ball housing.

During reassembly, slide the steering assembly in first, then push the pin back into its locking position.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Luke Matusiak

Member since: 04/26/2017

479 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team S23-G6, Livingston Spring 2017                        

                                                  Member of Cal Poly, Team S23-G6, Livingston Spring 2017 



                    CPSU-LIVINGSTON-S17S23G6                     


                                            3 Members                     


                                            6 Guides authored

Robin Hill - May 6, 2019

Thank you, thank you, thank you!

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team