Difficulty

Moderate

Steps

5

Time Required

                          6 - 10 minutes

Sections

3

  • Bin
  • 1 step
  • Steering Assembly
  • 2 steps
  • Ball Wheels
  • 2 steps

Flags

0

  • BackDyson DC39 Origin

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bin
  • Push down on the gray button located next to the power button to release the bin from the ball housing.
  • Pull the bin away, then up from the ball housing to remove it.
  • If the bin won’t fit back into place during re-assembly, you may need to push the grey button again.

Push down on the gray button located next to the power button to release the bin from the ball housing.

Pull the bin away, then up from the ball housing to remove it.

If the bin won’t fit back into place during re-assembly, you may need to push the grey button again.

1024

Step 2

              Steering Assembly
  • Place the ball housing on its side and orient it so that the underside of the steering assembly is facing you.
  • Remove the four 18.0 mm Torx 15 screws.

Place the ball housing on its side and orient it so that the underside of the steering assembly is facing you.

Remove the four 18.0 mm Torx 15 screws.

Step 3

  • Using two hands, hold the ball housing with the handle in one hand and the steering assembly base in the other.
  • Hold the steering assembly base near one of the wheels.
  • Pull the steering assembly base directly away from the ball housing. You should notice a pin release.
  • Push up on the steering assembly to remove it completely from the ball housing.
  • During reassembly, slide the steering assembly in first, then push the pin back into its locking position.

Using two hands, hold the ball housing with the handle in one hand and the steering assembly base in the other.

Hold the steering assembly base near one of the wheels.

Pull the steering assembly base directly away from the ball housing. You should notice a pin release.

Push up on the steering assembly to remove it completely from the ball housing.

During reassembly, slide the steering assembly in first, then push the pin back into its locking position.

Step 4

              Ball Wheels
  • Remove the 21.4 mm Torx 15 screw located at the center of the ball wheel.
  • There is one screw located at the center of each wheel.

Remove the 21.4 mm Torx 15 screw located at the center of the ball wheel.

There is one screw located at the center of each wheel.

Step 5

  • Pull the wheel away from the main body of the device.
  • This may require a lot of force. The plastic wheel may bend slightly.

Pull the wheel away from the main body of the device.

This may require a lot of force. The plastic wheel may bend slightly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Michael Hutcheson

Member since: 04/26/2017

297 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team S23-G6, Livingston Spring 2017                        

                                                  Member of Cal Poly, Team S23-G6, Livingston Spring 2017 



                    CPSU-LIVINGSTON-S17S23G6                     


                                            3 Members                     


                                            6 Guides authored