Difficulty
Moderate
Steps
7
Time Required
10 minutes
Sections
1
- Power Cord
- 7 steps
Flags
0
BackDyson Ball Animal
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Turn off and unplug the vacuum.
- Remove the vacuum canister from the front of the vacuum.
Turn off and unplug the vacuum.
Remove the vacuum canister from the front of the vacuum.
1024
Step 2
- Flip the vacuum around and remove the hose so it is not blocking the back of the vacuum.
Flip the vacuum around and remove the hose so it is not blocking the back of the vacuum.
Step 3
- There are four 15mm screws that must be removed with a Torx T15 screwdriver.
There are four 15mm screws that must be removed with a Torx T15 screwdriver.
Step 4
- After all the screws are released there are two tabs that must be pressed in and towards the center.
- The tabs can be pressed in one at a time but may require some force.
After all the screws are released there are two tabs that must be pressed in and towards the center.
The tabs can be pressed in one at a time but may require some force.
Step 5
- After removing the two tabs gently pull the face off the power supply.
After removing the two tabs gently pull the face off the power supply.
Step 6
- Follow the black cord from the power cord.
- Pinch the plastic piece.
- Remove from the metal tongue.
- When removing the cords, grab them from the plastic parts and not the cord.
Follow the black cord from the power cord.
Pinch the plastic piece.
Remove from the metal tongue.
When removing the cords, grab them from the plastic parts and not the cord.
Step 7
- There is also a black case that needs to be opened in order to remove the power cord.
- After opening the case pull apart the wire and attach the new wire.
- Again, make sure that you are pulling from the heads of the wires and not the wires themselves.
There is also a black case that needs to be opened in order to remove the power cord.
After opening the case pull apart the wire and attach the new wire.
Again, make sure that you are pulling from the heads of the wires and not the wires themselves.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Jonathan Gong-Guy
Member since: 04/17/2017
242 Reputation
1 Guide authored
Badges:
12
+9 more badges
Team
Cal Poly, Team S15-G5, Banghart Spring 2017
Member of Cal Poly, Team S15-G5, Banghart Spring 2017
CPSU-BANGHART-S17S15G5
4 Members
16 Guides authored
Jim Knox - Mar 3, 2019
Reply
Great tutorial! The pictures were awesome, I replaced my cord in about 15 minutes thanks to this post. The only thing you might want to add is the gray switch with the spring. Mine fell out while I was trying to put the unit back together and I had to research how it went back together correctly. Thanks again!
Jim
Robert W Marvin - May 27, 2022
Reply
I had the same spring lever issue. This video shows how to replace them.
