Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

2

  • Top Cover
  • 3 steps
  • Power Supply Board
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDynex DX-WBRDVD1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Top Cover
  • Remove the four 5mm Phillips #1 screws that connect the black outer shell to the silver back of the device.

Remove the four 5mm Phillips #1 screws that connect the black outer shell to the silver back of the device.

1024

Step 2

  • Remove the two 5mm screws on the left and right side panels.
  • There is one screw on each side that secures the cover to the body of the device.

Remove the two 5mm screws on the left and right side panels.

There is one screw on each side that secures the cover to the body of the device.

Step 3

  • Lift the black cover to a 45 degree angle from the rear of the device and pull the cover away entirely.
  • Check that the power cord is not preventing the device from opening or closing.

Lift the black cover to a 45 degree angle from the rear of the device and pull the cover away entirely.

Check that the power cord is not preventing the device from opening or closing.

Step 4

              Power Supply Board
  • Remove the 9-pin white wire from the power board (brown) that connects to the motherboard (green).

Remove the 9-pin white wire from the power board (brown) that connects to the motherboard (green).

Step 5

  • Remove the front plate of the device by removing the top two screws on either side and pulling the plate away.
  • Make sure to place the grounding wire between the screw and the device when reassembling.

Remove the front plate of the device by removing the top two screws on either side and pulling the plate away.

Make sure to place the grounding wire between the screw and the device when reassembling.

Step 6

  • Remove the 4 screws holding the power board to the body of the device.
  • Remember to connect a grounding wire to the screw next to the front panel and optical drive when reassembling.

Remove the 4 screws holding the power board to the body of the device.

Remember to connect a grounding wire to the screw next to the front panel and optical drive when reassembling.

Step 7

  • Press down on the plastic flap to unlatch the white clip on the edge of the power supply board.

Press down on the plastic flap to unlatch the white clip on the edge of the power supply board.

Step 8

  • Remove the power supply board.

Remove the power supply board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 8 other contributors 


                    Caleigh Firth

Member since: 04/05/2018

438 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Linn Benton Community College, Team S1-G2, Johnson Spring 2018                        

                                                  Member of Linn Benton Community College, Team S1-G2, Johnson Spring 2018 



                    LBCC-JOHNSON-S18S1G2                     


                                            4 Members                     


                                            6 Guides authored