Dymo Labelwriter 450 Eject Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Back Plate
2 steps
Eject Button
1 step

Flags

BackDYMO LabelWriter 450
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Plate

Make sure the device is unplugged. Then, turn over the device so that the label is readable.
Remove the two 15.7mm screws on the top of the device first, and then the two 26.5mm screws on the bottom (they are in the smaller holes and larger holes respectively) using a Phillips #1 screwdriver.
You need a spudger to orient the bottom screws so that they can be removed.

Make sure the device is unplugged. Then, turn over the device so that the label is readable.

Remove the two 15.7mm screws on the top of the device first, and then the two 26.5mm screws on the bottom (they are in the smaller holes and larger holes respectively) using a Phillips #1 screwdriver.

You need a spudger to orient the bottom screws so that they can be removed.

1024

Step 2

Once the Back Plate has been unscrewed, you will see the components from the top of the device plugged into the motherboard. You will only have 1-2 inches of clearance to unplug the components from the motherboard.
There are four components to unplug: the power cable connector, the two small no-fuss ribbon cable connectors, and the large no-fuss ribbon cable connector. The order does not matter.
This device has a blade located within the front panel. When handling the device, be careful not to touch the blade.

Once the Back Plate has been unscrewed, you will see the components from the top of the device plugged into the motherboard. You will only have 1-2 inches of clearance to unplug the components from the motherboard.

There are four components to unplug: the power cable connector, the two small no-fuss ribbon cable connectors, and the large no-fuss ribbon cable connector. The order does not matter.

This device has a blade located within the front panel. When handling the device, be careful not to touch the blade.

Step 3

              Eject Button

Turn the device upright and lift the lid. Carefully pull off the side panel that has the eject button on it until the panel gives way.

Turn the device upright and lift the lid. Carefully pull off the side panel that has the eject button on it until the panel gives way.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor

                    Jared Finkel

Member since: 10/09/2018

661 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team S1-G4, Leahy Fall 2018                        

                                                  Member of USF Tampa, Team S1-G4, Leahy Fall 2018 



                    USFT-LEAHY-F18S1G4                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team