Dymo Labelpoint 100 Rubber Transport Roller Replacement Repair Guide

Difficulty

Difficult

Steps

6

Time Required

                          15 - 20 minutes            

Sections

2

• Label Tape Cassette
• 2 steps
• Rubber Transport Roller
• 4 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackDYMO LabelPOINT 100

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Rear Panel               

• Slide the panel release button.
• Lift the panel.

Slide the panel release button.

Lift the panel.

1024

Step 2

              Remove Label Tape Cassette               

• Firmly press the cartridge release button with your finger.
• You may need to hold the cassette and/or entire device still while pressing the button.
• Lift the label tape cassette out of the device.

Firmly press the cartridge release button with your finger.

You may need to hold the cassette and/or entire device still while pressing the button.

Lift the label tape cassette out of the device.

Step 3

              Remove Screws To the Acess Panel               

• Use Phillips #00 screwdriver to remove three screws
• Remove blade cutter
• Use Phillips #00 screwdriver to remove remaining two screws from the battery compartment

Use Phillips #00 screwdriver to remove three screws

Remove blade cutter

Use Phillips #00 screwdriver to remove remaining two screws from the battery compartment

Step 4

• Gently pull the access panel up to separate from the device
• Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

Gently pull the access panel up to separate from the device

Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

Step 5

              Remove Back Panel               

• Use Phillips #00 screwdriver to remove six screws
• Slowly separate back panel
• Gears attached to the back panel are not secured and have a tendency to fall out. This will cause difficulty when reassembling

Use Phillips #00 screwdriver to remove six screws

Slowly separate back panel

Gears attached to the back panel are not secured and have a tendency to fall out. This will cause difficulty when reassembling

Step 6

              Remove Rubber Transport Roller               

• Gently pull rubber transport roller up to remove
• Replace rubber transport roller

Gently pull rubber transport roller up to remove

Replace rubber transport roller

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Deborah Canas                     

Member since: 09/25/2014

122 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team 5-2, Mcgee Fall 2014                        

                                                  Member of USF Tampa, Team 5-2, Mcgee Fall 2014 



                    USFT-MCGEE-F14S5G2                     


                                            4 Members                     


                                            6 Guides authored