Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Keypad
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackDYMO LabelPOINT 100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove Label Tape Cartridge
  • DYMO LabelPOINT 100 Label Tape Cassette Replacement

DYMO LabelPOINT 100 Label Tape Cassette Replacement

1024

Step 2

              Remove Screws To The Access Panel
  • Use Phillips #00 Screwdriver to remove the three screws that hold the upper portion of the access panel.
  • Remove the blade cutter assembly.
  • Use Phillips #00 Screwdriver to remove the last two screws located in the battery panel that holds the bottom portion of the access panel.

Use Phillips #00 Screwdriver to remove the three screws that hold the upper portion of the access panel.

Remove the blade cutter assembly.

Use Phillips #00 Screwdriver to remove the last two screws located in the battery panel that holds the bottom portion of the access panel.

Step 3

              Remove Access Panel
  • Gently remove the access panel from the right side of the device.
  • Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

Gently remove the access panel from the right side of the device.

Some electrical wiring will be exposed and will not detach. Be careful not to damage any electrical wiring when removing access panel.

Step 4

              Removing Circuit Board
  • Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board.
  • Gently lift the bottom of the circuit board, revealing the keypad.
  • Be careful not to damage any components on the circuit board when disassembling.

Use Phillips #00 Screwdriver to remove three screws that hold down the circuit board.

Gently lift the bottom of the circuit board, revealing the keypad.

Be careful not to damage any components on the circuit board when disassembling.

Step 5

              Remove Keypad
  • Remove the keypad from the front facing cover
  • When installing the new keypad, make sure all buttons are correctly set in each hole so that each button can be pressed.

Remove the keypad from the front facing cover

When installing the new keypad, make sure all buttons are correctly set in each hole so that each button can be pressed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Mike Dam

Member since: 09/25/2014

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team 5-2, Mcgee Fall 2014                        

                                                  Member of USF Tampa, Team 5-2, Mcgee Fall 2014 



                    USFT-MCGEE-F14S5G2                     


                                            4 Members                     


                                            6 Guides authored