Dymo Labelmanager 160 Charging Port Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          30 minutes            

Sections

3

• Batteries
• 2 steps
• Keyboard
• 4 steps
• Charging Port
• 3 steps

Flags

0

• BackDymo LabelManager 160

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Batteries               

• Place the device face-down to access the battery compartment.

Place the device face-down to access the battery compartment.

1024

Step 2

• Remove the compartment cover to reveal the batteries. Remove the 6 old batteries.

Remove the compartment cover to reveal the batteries. Remove the 6 old batteries.

Step 3

              Keyboard               

• To open the cartridge compartment, simply lift on the front of the device.

To open the cartridge compartment, simply lift on the front of the device.

Step 4

• Using a Phillips #0 screwdriver, remove the four 1.3mm screws from the cartridge compartment and two 1.2mm screws from the battery compartment.

Using a Phillips #0 screwdriver, remove the four 1.3mm screws from the cartridge compartment and two 1.2mm screws from the battery compartment.

Step 5

• Using a spudger or other tool, lift and remove the front of the device. This should be done all around the device to ensure the two parts split correctly.

Using a spudger or other tool, lift and remove the front of the device. This should be done all around the device to ensure the two parts split correctly.

Step 6

• Gently remove the rubber keyboard from the device.

Gently remove the rubber keyboard from the device.

Step 7

              Charging Port               

• Use wire cutters or scissors to cut the wires attached to the charging port, and remove the charging port.

Use wire cutters or scissors to cut the wires attached to the charging port, and remove the charging port.

Step 8

• Use wire strippers to strip the end of each wire.

Use wire strippers to strip the end of each wire.

Step 9

• Solder the black wire to the bottom-most node of the new charging port. Solder the red wire to the uppermost node of the new charging port. See the following link for soldering tips: How To Solder and Desolder Connections

Solder the black wire to the bottom-most node of the new charging port. Solder the red wire to the uppermost node of the new charging port. See the following link for soldering tips: How To Solder and Desolder Connections

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Andrew Ozga                     

Member since: 03/02/2017

155 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       IUPUI, Team S3-G4, Harley Spring 2017                        

                                                  Member of IUPUI, Team S3-G4, Harley Spring 2017 



                    IUPUI-HARLEY-S17S3G4                     


                                            4 Members                     


                                            1 Guide authored