Difficulty
Moderate
Steps
9
Time Required
5 - 10 minutes
Sections
1
- Eye Pipes
- 9 steps
Flags
0
BackDyedam Paintball Marker
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Eye Pipes
- Using a 3/32" allen key loosen the 2.5 mm screw from the buttstock.
- Remove the buttstock from the marker.
Using a 3/32" allen key loosen the 2.5 mm screw from the buttstock.
Remove the buttstock from the marker.
1024
Step 2
- Gently remove the barrel by turning it counter clockwise.
Gently remove the barrel by turning it counter clockwise.
Step 3
- Remove the magazine from the magwell using the magazine release button.
Remove the magazine from the magwell using the magazine release button.
Step 4
- Pull out the release switch on the back of the paintball bolt.
- Insert a 1/4" allen key into the release switch and turn counter clockwise until loose. This will take approximately 2 turns.
- Remove the bolt from your marker by pulling gently on the release switch.
- Careful as turning more than is needed to release the bolt could result in parts of your bolt becoming loose.
Pull out the release switch on the back of the paintball bolt.
Insert a 1/4" allen key into the release switch and turn counter clockwise until loose. This will take approximately 2 turns.
Remove the bolt from your marker by pulling gently on the release switch.
Careful as turning more than is needed to release the bolt could result in parts of your bolt becoming loose.
Step 5
- Use a 5/64 " allen key to remove the four 2 mm screws connecting the magwell to the body of the paintball marker.
- Be gentle when removing the magwell as the eyes of your paintball marker are directly beneath. Improper removal could damage these pieces.
Use a 5/64 " allen key to remove the four 2 mm screws connecting the magwell to the body of the paintball marker.
Be gentle when removing the magwell as the eyes of your paintball marker are directly beneath. Improper removal could damage these pieces.
Step 6
- Using a 5/64 " allen key. Remove the two 2 mm screws connecting the hand guard to the receiver of the marker.
Using a 5/64 " allen key. Remove the two 2 mm screws connecting the hand guard to the receiver of the marker.
Step 7
- Using a 5/64" allen key loosen the 2 mm screw holding the barrel seat inside the receiver.
Using a 5/64" allen key loosen the 2 mm screw holding the barrel seat inside the receiver.
Step 8
- Using a clean part of your hand. Remove the barrel seat from the receiver of the paintball marker.
Using a clean part of your hand. Remove the barrel seat from the receiver of the paintball marker.
Step 9
- Using a clean part of your hand. Remove the eye pipes from the magazine well of the paintball marker.
Using a clean part of your hand. Remove the eye pipes from the magazine well of the paintball marker.
Now that your gun is taken apart and your eye pipes cleaned or replaced. You can follow these instructions in reverse to put your marker back together
Cancel: I did not complete this guide.
Attached Documents
- 2015_DAM_MANUAL_new.pdf
- PDF - 16.76 mb
- View
2015_DAM_MANUAL_new.pdf
PDF - 16.76 mb
Author
with 1 other contributor
James Rogers
Member since: 02/03/2019
169 Reputation
1 Guide authored
Badges:
2
Team
University of Advancing Technology, Team S1-G10, Beam Spring 2019
Member of University of Advancing Technology, Team S1-G10, Beam Spring 2019
UAT-BEAM-S19S1G10
1 Member
1 Guide authored
