Durofix Rv332 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 - 45 minutes

Sections

Battery
3 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Missing Prerequisites

This guide is missing information on how to start the process. Make a prerequisite guide!

Better Introduction

Improve this guide by completing or revising its introduction.

BackDurofix RV332
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Remove the six 13mm case screws with a #0 phillips screwdriver.
Separate the screwdriver housing with a plastic opening tool.
Remove battery casing half to expose screwdriver internals.

Remove the six 13mm case screws with a #0 phillips screwdriver.

Separate the screwdriver housing with a plastic opening tool.

Remove battery casing half to expose screwdriver internals.

1024

Step 2

Locate battery
Remove battery, printed circuit board, LED, and motor assembly from screwdriver casing.

Locate battery

Remove battery, printed circuit board, LED, and motor assembly from screwdriver casing.

Step 3

Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.
Strip the ends of the wires attached to the printed circuit board 1/4 inch above the ends of the cut wires.
Solder the new battery to the stripped wires attached to the printed circuit board.
Wrap the newly soldered connections with electrical tape.

Using side cutters, cut the red and black wires connecting the battery to the printed circuit board just after the shrink wrap tubing.

Strip the ends of the wires attached to the printed circuit board 1/4 inch above the ends of the cut wires.

Solder the new battery to the stripped wires attached to the printed circuit board.

Wrap the newly soldered connections with electrical tape.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors

                    Brennan Wade

Member since: 02/21/2014

113 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Michigan Tech, Team 5-5, Lauer Spring 2014                        

                                                  Member of Michigan Tech, Team 5-5, Lauer Spring 2014 



                    MTU-LAUER-S14S5G5                     


                                            3 Members                     


                                            5 Guides authored

Needs Better Images#

Missing Prerequisites#

Better Introduction#

Introduction#

What you need#

#

#

#

#

#

Team#

#