Durofix Rv332 Battery Led Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          15 - 30 minutes            

Sections

1

• Battery LED
• 4 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

• BackDurofix RV332

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery LED               

• Remove the six 13 mm case screws with a #0 Phillips screwdriver.

Remove the six 13 mm case screws with a #0 Phillips screwdriver.

1024

Step 2

• Using a plastic opening tool, separate the casing halves to expose the contents of the cordless screwdriver.

Using a plastic opening tool, separate the casing halves to expose the contents of the cordless screwdriver.

Step 3

• Remove printed circuit board, LED, battery, and motor assembly from the screwdriver casing.
• Use a soldering iron to melt the solder from the LED’s two pins on the printed circuit board.
• Remove the LED from the circuit board while the solder is still melted.

Remove printed circuit board, LED, battery, and motor assembly from the screwdriver casing.

Use a soldering iron to melt the solder from the LED’s two pins on the printed circuit board.

Remove the LED from the circuit board while the solder is still melted.

Step 4

• Place the positive leg of the new LED through the positive hole in the printed circuit board and solder it into place.
• Place the negative leg of the LED through the negative hold in the printed circuit board and solder it into place.

Place the positive leg of the new LED through the positive hole in the printed circuit board and solder it into place.

Place the negative leg of the LED through the negative hold in the printed circuit board and solder it into place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Tyler Vincent                     

Member since: 02/24/2014

464 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Michigan Tech, Team 5-5, Lauer Spring 2014                        

                                                  Member of Michigan Tech, Team 5-5, Lauer Spring 2014 



                    MTU-LAUER-S14S5G5                     


                                            3 Members                     


                                            5 Guides authored