Droid Ultra Xt1080 Charging Port Replacement Repair Guide

Difficulty

Difficult

Steps

8

Time Required

                          35 minutes            

Sections

1

• Charging Port
• 8 steps

Flags

0

• BackMotorola Droid Ultra

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Charging Port               

• Remove SIM card tray from the device with a plastic opening tool.

Remove SIM card tray from the device with a plastic opening tool.

1024

Step 2

• Once SIM card tray is removed press the spudger between the plastic case and the frame of the device until you hear a snap.
• Work your away around the device until all the plastic clips are undone.
• Be gentle with the plastic to make sure it doesn’t break.

Once SIM card tray is removed press the spudger between the plastic case and the frame of the device until you hear a snap.

Work your away around the device until all the plastic clips are undone.

Be gentle with the plastic to make sure it doesn’t break.

Step 3

• Remove the five screws on top of the device with a T5 Torx.
• Remove the single screw holding the camera with a T4 Torx.
• Remove the two screws on the bottom of the device with a T5 Torx.

Remove the five screws on top of the device with a T5 Torx.

Remove the single screw holding the camera with a T4 Torx.

Remove the two screws on the bottom of the device with a T5 Torx.

Step 4

• Once the screws are removed, use a plastic spudger and lift up the two plastic pieces that were secured by the screws.

Once the screws are removed, use a plastic spudger and lift up the two plastic pieces that were secured by the screws.

Step 5

• Remove the four T5 Torx screws securing the motherboard.

Remove the four T5 Torx screws securing the motherboard.

Step 6

• Gently pry the motherboard out of the frame of the device.

Gently pry the motherboard out of the frame of the device.

Step 7

• Once the motherboard is free flip it over on its back so all the components are showing.

Once the motherboard is free flip it over on its back so all the components are showing.

Step 8

• To fully replace the charging port you need to desolder the port and solder a new one in.

To fully replace the charging port you need to desolder the port and solder a new one in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    knoyes                     

Member since: 10/30/2018

785 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       UMass Dartmouth, Team S3-G8, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S3-G8, Peak Fall 2018 



                    UMASSD-PEAK-F18S3G8                     


                                            3 Members                     


                                            10 Guides authored