Difficulty

Moderate

Steps

8

Time Required

                          30 minutes

Sections

1

  • Battery
  • 8 steps

Flags

0

  • BackMotorola Droid Ultra

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove the SIM card tray from the side of the device using a plastic opening tool.

Remove the SIM card tray from the side of the device using a plastic opening tool.

1024

Step 2

  • After properly removing the SIM card tray take your spudger and press it in between the plastic case and the frame of the device until you hear a snap.
  • Work your way from the top and the other side to confirm all the clips are disconnected.
  • Be gentle when performing this so you don’t crack or break the plastic.

After properly removing the SIM card tray take your spudger and press it in between the plastic case and the frame of the device until you hear a snap.

Work your way from the top and the other side to confirm all the clips are disconnected.

Be gentle when performing this so you don’t crack or break the plastic.

Step 3

  • Remove the five screws on top of the device with a T5 Torx.
  • Remove the single screw holding the camera with a T4 Torx.
  • Remove the two screws on the bottom of the device with a T5 Torx.

Remove the five screws on top of the device with a T5 Torx.

Remove the single screw holding the camera with a T4 Torx.

Remove the two screws on the bottom of the device with a T5 Torx.

Step 4

  • After the top and bottom screws are removed remove the top and bottom plastic pieces that were secured to the device.

After the top and bottom screws are removed remove the top and bottom plastic pieces that were secured to the device.

Step 5

  • Begin to gently pry up the battery from the frame with a plastic opening tool to release it from its adhesive securing.

Begin to gently pry up the battery from the frame with a plastic opening tool to release it from its adhesive securing.

Step 6

  • Remove the four T5 Torx screws securing the motherboard.

Remove the four T5 Torx screws securing the motherboard.

Step 7

  • Gently pry the motherboard out of the frame using the nylon spudger.
  • Make sure not to damage the LCD cable in the process.

Gently pry the motherboard out of the frame using the nylon spudger.

Make sure not to damage the LCD cable in the process.

Step 8

  • Disconnect the LCD cable with a spudger from the motherboard by gently lifting up the two connectors.

Disconnect the LCD cable with a spudger from the motherboard by gently lifting up the two connectors.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 1 other contributor 


                    knoyes

Member since: 10/30/2018

785 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team S3-G8, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S3-G8, Peak Fall 2018 



                    UMASSD-PEAK-F18S3G8                     


                                            3 Members                     


                                            10 Guides authored